Parts for Kitchenaid KECC662BPW00: 02 - Optional Parts (Not Included) Parts

This rubber grommet cushions and seals an appliance opening to reduce noise, protect wiring or components from chafing, and help keep parts aligned. It's a small but important wear item that restores proper fit where mounted. What it does:

• Cushions and isolates moving parts to reduce vibration and noise
• Protects wires, hoses, or sheet metal from rubbing and wear
• Helps form a snug seal around openings to keep components stable
• Commonly replaced when cracked, torn, hardened, or missing

• One rubber grommet (quantity: 1)

• Disconnect power (and water if applicable) before beginning any repair
• Remove access panels as needed to reach the mounting location; check orientation before removing old grommet
• Press new grommet into the opening until fully seated; trim only if explicitly required by your appliance model
• Replace the grommet if it shows cracking, deformation, or hardening; avoid using solvents or adhesives unless specified by OEM

This switch seal is a small rubber gasket that protects a control or door switch from moisture and debris, helping maintain reliable operation and prevent damage to the switch assembly. What it does:

• Creates a moisture- and dust-resistant barrier around a switch to reduce shorting and corrosion
• Helps keep switches operating smoothly by blocking contaminants that cause sticking or intermittent contacts
• Supports safe electrical performance by keeping water away from switch terminals and housings
• Common symptom linkage: switch malfunction, intermittent control, or moisture-related failures near switch area

• Disconnect power to the appliance before inspecting or replacing the seal
• Remove surrounding trim or components carefully to avoid damaging the switch or housing
• Confirm correct orientation and full seating of the seal during reassembly for an effective barrier
• If the switch shows damage or corrosion, replace the switch assembly as well

This 10-32 terminal block nut fastens wire lugs to the appliance's terminal studs. Replacing a missing, stripped, or corroded nut restores a tight, reliable connection and helps prevent heat damage or intermittent power at the connection.

• Secures wire lugs to a 10-32 terminal stud for a solid electrical connection
• Restores proper clamping force when the original nut is stripped, corroded, or missing
• Helps address loose/burned terminal connections, heat discoloration, or intermittent power at the block
• Suitable for terminal block and similar 10-32 stud applications on compatible appliances

• Disconnect power at the breaker or unplug the appliance before servicing
• Inspect the terminal block, studs, and wiring for heat damage; replace any damaged components
• Clean threads and start the nut by hand to avoid cross-threading; tighten firmly without overtightening
• If the stud turns while tightening, hold it with an appropriate tool to protect the block

Razor blade scraper.

Size: 10 fl. oz. Used on glass, ceramic and porcelain cooktops.