Parts for Kitchenaid KDRS483VSS00: 11 - Optional Parts

This wire harness is a factory-style replacement assembly that restores electrical connections for affected appliance circuits, helping re-establish reliable power and signal routing for safe operation. What it does:

• Replaces damaged or corroded wiring that can cause intermittent power, controls not responding, or component failures
• Restores proper connections between control boards, switches, sensors, and motors where applicable
• Helps eliminate burning smells or visible wire damage linked to failed harnesses
• Provides correct connector fit and wire routing to maintain original appliance function

• One complete wire harness assembly as shown

• Only install if the appliance is unplugged and power is disconnected at the breaker
• Inspect connectors and mating parts for damage before installation; replace any additional damaged components
• Route wires following original paths and secure with existing clips to avoid contact with hot or moving parts

Wire harness for gas ranges. Connects electrical components inside your range. Replace if wires are frayed, damaged, or connections are loose or broken.

Control knob for gas ranges and cooktops. Mounts on the control panel to adjust burner settings. Replace if cracked, broken, or difficult to turn.

This bushing is a small sleeve-style bearing that supports a rotating shaft and reduces metal-to-metal wear for smooth operation. It helps restore proper alignment and quiet operation when the original bushing is worn. What it does

• Guides and supports a rotating shaft or spindle to reduce friction and wear
• Prevents metal-to-metal contact that can cause grinding or scoring
• Helps stop rubbing, squeaking, or vibration caused by a worn bearing surface
• Restores proper alignment of the moving component for smoother operation

• Inspect the mating shaft and housing for wear or damage before installing a new bushing
• Press or seat the bushing evenly; avoid hammering directly on the bushing surface
• Use proper tools and safety gear; disconnect power or unplug the appliance before service
• If surrounding parts are worn (shafts, seals, clips), replace them to prevent premature bushing failure

Anchor tip bracket for gas ranges. Secures and stabilizes internal components. Replace if bent, broken, or missing to restore proper fitment.

Replacement broiler pan for ranges and ovens. Holds food under high heat while collecting drippings. Order if your pan is missing, warped, or damaged.

Replacement hex nut for dryer terminal blocks and electrical connections. Secures terminal components. Needed when original is stripped, missing, or damaged.

Size: 10 fl. oz. Used on glass, ceramic and porcelain cooktops.