Parts for Kitchenaid KDRS483VSS03: 08 - 18`` Oven Door Parts

This inner oven door glass replaces a cracked, chipped or cloudy inner panel so the oven door seals properly and the cavity stays protected. Restores a clear view of the oven interior and helps maintain normal heat containment. What it does:

• Replaces damaged inner glass in the oven door to stop drafts and reduce heat loss
• Restores a clear viewing window for monitoring cooking without opening the door
• Prevents loose or broken glass pieces from falling into the oven cavity
• Helps stop rattling caused by a cracked or shifted inner panel

• One inner oven door glass panel

• Disconnect power to the appliance and ensure the oven and door are fully cool before starting
• Handle glass with gloves and eye protection; place on a soft, flat surface to avoid scratches
• Installation typically requires removing the oven door and unscrewing retaining hardware — keep track of all fasteners
• If the original glass was double-pane or sealed, do not attempt to separate or modify panes; replace as a unit

This 8-32 x 3/8 screw secures panels, brackets, and internal components in your appliance so everything stays aligned and tight. Replace worn or missing hardware to restore a solid, rattle-free fit and safe operation.

• Fastens components to frames, brackets, or panels
• Helps reduce vibration, rattling, and misalignment
• Replaces missing, stripped, or corroded screws
• Correct 8-32 machine thread for tapped holes in compatible assemblies

• Disconnect power before servicing; shut off gas or water if applicable
• Start threads by hand to avoid cross-threading
• Tighten snugly without overtightening to prevent stripping

This end cap fits onto a refrigerator or freezer door handle to protect the handle end and provide a finished look. It restores secure handle alignment and appearance after damage or wear. What it does:

• Covers and protects the exposed end of a door handle for a clean, finished appearance
• Helps keep the handle seated and prevents snagging or sharp edges
• Commonly replaced when cracked, worn, or broken during normal use or accidental impact
• Matches original fit and mounting points for straightforward replacement

• One end cap

• Install with the door open and handle supported to avoid strain on the mounting hardware
• May require removal of the handle or a few fasteners depending on model
• Use proper tools and avoid overtightening to prevent cracking the new end cap
• Disconnect power to any nearby powered components before working

This replacement screw secures appliance panels and components so they stay tight and aligned during use. Replacing a missing or damaged screw restores a solid fit and helps eliminate rattles, loose trim, or shifting parts.

• Fastens brackets, panels, trim, or components to the appliance chassis
• Helps correct loose or missing hardware after vibration or service
• Replaces stripped, rusted, or broken screws
• Can reduce rattling noises or misaligned parts caused by missing fasteners

• Disconnect power; for gas appliances, also shut off the gas supply
• Support the part being fastened; start threads by hand to avoid cross-threading
• Use the correct driver size; tighten snugly without overtightening
• Replace hardware with the exact part number to ensure proper fit