Parts for Frigidaire CPLCF489DC2: 13 - Oven Door Parts

This aluminum-faced door insulation panel replaces the factory insulation inside a refrigerator or freezer door to help restore proper door thermal barrier and reduce air leakage. It fits behind the inner door panel and helps the appliance maintain set temperatures. What it does:

• Replaces damaged or degraded door insulation to improve the door's thermal barrier
• Helps reduce warm spots and excess frost that can result from poor door insulation
• Can help normalize compressor run time caused by air leakage around the door cavity
• Restores the door's internal padding and support for the inner door panel

• Always unplug the appliance before starting; remove food and secure shelves
• Remove the inner door panel or liner to access and replace the insulation
• Handle insulation carefully; avoid compressing or puncturing the panel during installation
• Reassemble door components in reverse order and verify a proper seal before use

Length: Approx. 82 1/2"

This spacer positions and separates mounting components to maintain proper clearance and alignment, helping panels and hardware fit securely. It prevents rubbing and keeps assemblies stable for quieter, correct operation. What it does:

• Maintains required gap between panels or mounting surfaces to prevent binding or interference
• Keeps screws, brackets, and panels aligned for a proper fit
• Reduces vibration and rattling caused by loose or misaligned parts
• Helps restore proper clearance when replacing worn or missing spacers

• Disconnect power before accessing internal panels or fasteners
• Replace like-for-like; spacer location and orientation during removal
• Handle surrounding trim and panels carefully to avoid damage
• If fasteners are damaged or stripped, replace them rather than over-tightening

Specs: 8 - 18 x 0.500

This #10-32 x 3/4-inch machine screw secures appliance components such as panels, brackets, and handles. Using the correct length and thread helps restore a snug, rattle-free hold wherever this screw is specified by the manufacturer.

• Fastens components with a #10-32 machine thread and 3/4-inch length
• Helps keep panels, trim, brackets, or handles secured and aligned
• Replaces missing, stripped, or corroded hardware
• Common signs include loose or wobbly parts, rattling, missing screws, or damaged screw heads/threads

• Disconnect power before servicing; if working near a water connection, shut off the water supply
• Use the correct driver/bit and start threads by hand to avoid cross-threading
• Tighten snugly; do not overtighten to prevent stripping plastic or threads
• Reuse any model-specific washers or spacers if present

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts