Parts for Thermador C302UB: Oven Modules C27 And C30 Parts

This part has been discontinued by the manufacturer and is no longer available.

Heat reflector for electric wall ovens. Installs around heating elements to direct heat evenly. Replace if cracked, warped, or missing.

Convection rack support for wall ovens. Holds and stabilizes the oven rack during cooking. Replace if cracked, bent, or broken to restore proper support.

This catalyzer element helps neutralize smoke and odors generated during cooking by breaking down airborne particles as they pass through the microwave's ventilation system. It is typically located near the exhaust area of the unit. Replace this part if you notice persistent smoke odors, reduced ventilation effectiveness, or visible deterioration of the catalyzer material.

Oven not heating or baking unevenly? This 27-inch bake element restores proper bottom heat. Moderate DIY repair requiring electrical disconnect.

Oven not heating or baking unevenly? This lower bake element restores consistent heat for even cooking. DIY-friendly repair in under 30 minutes.

Welded convection baffle directs airflow in wall ovens and ranges. Replace if cracked, damaged, or missing to restore proper air circulation.

This is the ventilation duct that directs airflow through the microwave to cool internal components and exhaust hot air. It serves as an air baffle to channel ventilation properly within the unit. Replace this duct if airflow seems restricted, the microwave is overheating, or the duct is cracked or warped.

Oven not heating evenly in convection mode? This rear convection heating element restores proper temperature. DIY-friendly, typically installs in 10-20 minutes.

Fix intermittent power or component failure with this range socket electrical connector. Restores secure wiring connections in electric and gas ranges.

Flexible conduit cable that protects electrical wiring in your oven. Replaces cracked, damaged, or worn conduit. Installs between junction box and unit.

A 1/2 in. 90° connector used to join the appliance water inlet to the household supply, restoring a secure right-angle connection and helping prevent kinks or strain at the hose junction. What it does:

• Creates a sealed right-angle connection between the appliance water inlet and supply line
• Restores proper water flow when the previous connector is damaged or leaking
• Reduces strain and hose kinking at the inlet fitting
• Commonly replaced to stop visible leaks or water drips at the connection

• Turn off the water supply and disconnect power to the appliance before installing
• Use appropriate thread sealant or tape where required by the appliance manufacturer
• Hand-start threads to avoid cross-threading; tighten with a wrench until snug — do not overtighten

This part has been discontinued by the manufacturer and is no longer available.

Wire harness for wall oven lower door latch assembly. Connects latch mechanism to control system. Replace if wires are damaged, frayed, or connectors broken.

Fix a blank or flickering oven display with this display signal harness. Connects the control board to the display panel. Moderate DIY repair.

Communication signal wire harness for wall ovens and ranges. Connects control boards to transmit data signals. Replace if wires are frayed or damaged.

Wire harness that connects to your wall oven's door latch assembly. Replace if the harness is damaged, wires are frayed, or connectors are broken.

Phillips pan head mounting screw for cooktops and ranges. Replace this zinc-coated fastener if lost, stripped, or corroded during appliance repair.