Parts for Jenn-Air 2280EEL: 01 - Oven Parts

This metal tailpipe directs dryer exhaust from the appliance outlet to the vent system, restoring proper airflow and helping prevent exhaust leakage. It's a direct-fit replacement that reinstates safe venting. What it does

• Channels exhaust air from the dryer outlet to the vent duct to maintain proper airflow
• Helps prevent exhaust leakage behind the dryer that can cause odor or moisture issues
• Stops rattling or misalignment at the dryer outlet caused by a damaged or bent tailpipe
• Supports safe venting performance that can affect drying efficiency

• One tailpipe

• Disconnect power; for gas dryers, shut off the gas supply before starting
• Basic tools (screwdriver/socket) typically required; follow OEM installation instructions
• Ensure the tailpipe is seated and secured to the dryer outlet and vent duct with proper clamps or screws
• After installation, check for leaks, proper alignment, and test dryer operation

This part has been discontinued by the manufacturer and is no longer available.

This replacement glass panel restores the smooth, protective surface on the appliance when the original panel is cracked or broken. It helps maintain a clean appearance while shielding the components mounted behind the glass. What it does:

• Forms the visible glass surface on the appliance
• Protects internal components from spills and debris
• Restores a clean, finished look after breakage or heavy scratching
• Common fix for cracked, chipped, shattered, or missing glass

• 1 glass panel

• Disconnect power (and gas, if applicable) and allow the unit to cool completely
• Wear cut-resistant gloves; handle glass carefully
• Transfer any brackets, trim, or seals from the original panel as instructed
• Do not overtighten fasteners; verify proper alignment before restoring power

This dishwasher crockery basket holds and organizes flatware and small items during the wash cycle. Replacing a damaged basket helps keep pieces upright, prevents items from slipping through, and supports consistent cleaning results.

• Organizes and separates silverware so wash spray reaches all surfaces
• Helps keep small items from falling into the tub, sump, or spray arm area
• Restores stable storage when the original basket is cracked, warped, or missing
• Common symptoms: broken grid walls, missing sections, sharp edges, or utensils tipping over

• Turn the dishwasher off and allow any hot surfaces to cool before reaching inside
• Lift out the old basket from the lower rack and set the new basket in the same location or hooks
• Ensure the lower spray arm spins freely with the basket in place
• Load utensils per your owner's manual to avoid blocking spray or causing damage

A replacement base panel that restores the lower front appearance and protects the appliance's internal components from dust and debris. Replaces a damaged, dented, rusted or missing lower kick panel for a clean, finished look. What it does:

• Covers and protects the appliance base and internal components from accidental contact and debris.
• Restores the finished appearance of the appliance's lower front area.
• Helps keep dust and small objects out of the cabinet and vent openings.
• Secures to the cabinet frame with existing clips or screws; prevents loose or rattling trim.

• Disconnect power to the appliance before attempting service.
• Remove lower access panel or toe-kick and retain hardware; re-use existing mounting clips/screws unless replacements are specified.
• Lift or align the panel into place and secure with the original fasteners; do not force or overtighten.

This inner door panel forms the inside surface of the dishwasher door. It supports key door components and helps seal the tub, keeping water and heat contained for reliable, quiet operation.

• Provides the structural interior panel of the door
• Mounts the detergent dispenser, latch, and vent components
• Works with the door gasket to contain water and steam
• Typical symptoms include dents/rust, leaks at the door area, or a loose/misaligned dispenser or latch

• Disconnect electrical power and turn off the water supply before starting
• Open the door, support the outer panel, and remove perimeter screws to separate the door halves
• Transfer the dispenser, latch/lock, vent, wiring, and insulation from the old panel to the new one; reuse hardware and seals if in good condition
• Ensure the door gasket seats evenly; after reassembly, run a short test cycle and check for leaks

This part has been discontinued by the manufacturer and is no longer available.

This outer door panel replaces a damaged or worn exterior door surface to restore appearance and protect internal door parts. It provides the finished outer surface that customers see and touch on the appliance. What it does:

• Replaces a dented, scratched, or rusted outer door surface
• Restores the appliance's finished exterior and curb appeal
• Protects internal door components and insulation from damage
• Helps maintain a proper seal by providing correct door alignment

• One outer door panel

• Remove power (unplug or switch off breaker) before beginning work
• Some installations require removing the inner door panel, glass, or trim; handle and hardware may be separate
• Use appropriate hand tools; avoid bending or scratching the new panel during install

This outer door panel replaces a damaged or dented front panel to restore the dishwasher's appearance and protect internal components. It provides the external surface that you see and touch when loading and unloading dishes. What it does:

• Replaces the dishwasher's front outer door panel for cosmetic and protective repair
• Restores a smooth, secure surface where the control bezel and handle attach
• Helps stop drafts, moisture intrusion, and visible dents or scratches on the front
• Commonly used when the exterior is dented, scratched, or warped and needs renewal

• Remove power and water supply to the appliance before starting any repair
• Keep screws and fasteners organized; transfer existing hardware
• Inspect inner door components and insulation while door is open; replace damaged clips or seals as needed