Parts for Kenmore 101.906624 (101906624, 101 906624): Oven Structure Parts

Side or bottom exhaust vent kit for dryers. Relocates dryer vent from rear to side or bottom position. Includes metal duct, hardware, and instructions.

Seals and cushions the inner glass pane inside your oven door to contain heat and prevent rattling. Replace when cracked or flattened. Confirm fit.

A short, ribbed stainless steel wash tub assembly that replaces a damaged or corroded inner tub to restore proper wash action and contain laundry during cycles. Fits compatible top-load washer tubs that use the short, ribbed stainless design. What it does:

• Holds and contains clothes during wash and rinse cycles; transfers water and motion from the agitator/impeller.
• Ribbed stainless surface helps move and separate laundry for better cleaning action.
• Replaces tubs with cracks, heavy corrosion, or persistent leaks originating from the tub.
• Restores structural integrity and reduces risk of clothes damage from sharp edges or deformed surfaces.

• One (1) short, ribbed stainless steel wash tub assembly.

• Tub removal may require disassembly of cabinet, spin basket, and associated fasteners.
• Disconnect power and water supply before servicing; follow all manufacturer safety guidelines.
• Handle stainless surfaces carefully to avoid dents; verify seals, gaskets, and mounting hardware are in good condition and replaced as needed.

This idler lever with spring is the replacement tensioning assembly that keeps the dryer drive belt under proper tension so the drum turns smoothly. Replaces worn or broken idler hardware to restore normal belt tracking and drum motion. What it does:

• Provides tension on the drive belt so the drum rotates without slipping
• Maintains correct belt routing and alignment during operation
• Helps eliminate squealing or grinding noises caused by a failed idler
• Restores normal tumbling when a worn idler allows the belt to slip

• Disconnect power (and gas supply if applicable) before starting any repairs
• Access typically requires removing the dryer front or rear panel to reach the idler assembly
• Support or relieve the drive belt when removing/installing the idler to avoid damage
• Inspect the belt and pulley for wear and replace if visibly scored or stretched

This part has been discontinued by the manufacturer and is no longer available.

The Hose Clamp is an OEM part for Whirlpool appliances. It secures hoses in place, ensuring a tight connection and preventing leaks in various systems such as washing machines, dishwashers, and refrigerators. This clamp is crucial for maintaining the integrity of the water or air lines it secures.

Causes of a bad hose clamp include wear and tear over time, exposure to water and detergents, or mechanical stress from repeated tightening and loosening.

Symptoms of a bad hose clamp include:

• Leaks at the hose connection points
• Hoses slipping off the connections
• Visible rust or damage on the clamp
• Reduced appliance efficiency due to leaks

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.