Parts for Kitchenaid KUCC151T4: 06 - Panel And Control Parts

Retainer bracket secures internal components in your compactor. Replace if cracked, broken, or snapped to restore proper alignment and prevent rattling.

Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.

This part has been discontinued by the manufacturer and is no longer available.

Compactor won't turn on or stay running? This rotary switch kit controls power and operation. DIY-friendly repair in about 30 minutes with basic tools.

Replacement control knob for trash compactors. Mounts to the control shaft to select cycles and functions. Needed when original is cracked, stripped, or missing.

Secures the rotary control switch to your trash compactor's front panel. Replace if stripped, missing, or loose to keep the control knob stable and aligned.

Fix a refrigerator light that won't turn on or off when you open the door. This push-button switch senses door position. DIY repair in 30 minutes.

Fix a compactor that won't activate extra pack or dense pack mode. This rocker switch restores full functionality. Simple 5-minute DIY repair.

Fan mount assembly for trash compactors. Secures and supports the cooling fan in place. Replace if cracked, broken, or missing to restore proper fit.

This power cord plate covers and secures the oven/range power cord where it enters the appliance, keeping the connection protected and helping prevent strain on the cord. It restores a finished look and helps keep wiring safely routed. What it does:

• Covers the terminal block area to protect power connections from dirt and accidental contact
• Helps keep the power cord routed and secured to reduce strain on the cord and terminals
• Can prevent air/dust intrusion behind the control cavity that could affect components
• Common replacement when the original plate is cracked, broken, or missing

• Always disconnect power at the breaker or unplug the appliance before starting work
• Typically attaches with two screws; keep screws and any gaskets from the old piece for reuse if undamaged
• Check the cord strain relief/terminal connections while replacing the plate; do not touch live terminals
• If wiring or the cord itself is damaged, replace or repair those parts per manufacturer instructions

Ground screw secures transmission housing and console components in washers. Replaces missing, stripped, or corroded screws. 10-24 x 3/8 inch fastener.

Fix a compactor that won't activate extra pack or dense pack mode. This rocker switch restores full functionality. Simple 5-minute DIY repair.

Charcoal filter eliminates odors in your trash compactor. Replace every 2-3 months or when odors appear. Confirm fit with your model number.

Hex head screw for trash compactor assembly. Replaces lost, stripped, or damaged screws during repairs. Essential hardware for securing components.

Fan mount assembly for trash compactors. Secures and supports the cooling fan in place. Replace if cracked, broken, or missing to restore proper fit.

S-clip secures components in your trash compactor. Replace if bent, broken, or causing rattling noises. Verify fit with your model number.

S-clip secures components in your trash compactor. Replace if bent, broken, or causing rattling noises. Verify fit with your model number.