Parts for Viking Range VGSS30: Panel / Oven Assembly Parts

Restore smooth, controlled movement to your appliance door or lid with this hinge assembly. Replacing a worn hinge corrects sagging, binding, and poor closure so the door aligns and closes properly for reliable everyday use.

• Provides the pivot and support for the door or lid
• Controls opening/closing motion for smooth, consistent operation
• Helps maintain alignment so the door closes flush with the frame
• Common symptoms of a failing hinge: sagging, binding, squeaking/popping, or a door that won't close fully or evenly

• Disconnect power and, shut off gas/water before servicing
• Support the door; mark hinge positions; remove mounting screws carefully
• Transfer any brackets or covers from the original hinge if needed
• After installation, check alignment and closure; adjust per the service manual

This replacement oven door gasket seals the oven cavity to retain heat for better cooking performance and lower energy loss. Designed for 30" and 36" ovens, it restores the door seal to reduce heat escape and uneven baking. What it does

• Creates a tight door seal to help keep oven heat inside the cavity
• Reduces heat loss that can cause long preheat times and uneven cooking
• Helps prevent excessive surface heat around the door and nearby cabinetry
• Replaces cracked, flattened, or worn gasket material that no longer seals

• One oven door gasket

• Allow the oven to cool and disconnect power before starting any work
• Remove the old gasket first; most gaskets press or tuck into a channel around the door
• Press the new gasket into the retainer channel evenly, working around the door until fully seated
• Avoid sharp tools that can damage the gasket; check the seal after installing by closing the door and inspecting for gaps

This listing is for a Viking oven bottom pan assembly. The oven bottom pan sits above the flames in the bottom section on specific models of Viking gas ovens. Their intended use is for stopping grease and other food byproducts from stoking the fire from the gas igniter. This model of Viking gas seems to have a few specific indicators that could signal a damaged bottom pan. There could be a possible gas smell coming from the oven and a sound of popping flames. This is because the pan is moving, allowing more gas fumes to exit the appliance. The flames popping are most likely from liquid spilling onto the igniter area. Always unplug the range from any electrical outlet and gas sources before beginning repairs. Wear gloves when working around the range area and look out for sharp edges.This is a genuine OEM part and is sourced individually from the original manufacturer. This part is compatible with Viking, KitchenAid, and Whirlpool appliances.

This metal heat shield protects the lower oven cavity and components from excessive heat, helping maintain safe operation and appliance longevity. Fits behind the oven floor to block heat and direct airflow. What it does:

• Shields oven base and insulation from direct heat to prevent damage and excessive wear
• Helps maintain more consistent internal oven temperatures by directing heat flow
• Reduces risk of heat transfer to surrounding components and cabinetry
• Common symptom: visible scorch marks, warped panels, or burned insulation under the oven

• One oven bottom heat shield

• Disconnect power (and gas if applicable) before servicing the appliance
• Remove oven racks and any access panels to reach the lower cavity
• Use basic hand tools; support the shield during removal/installation to avoid dropping
• Handle edges carefully — metal parts can be sharp