Bosch Range SM272BW Parts

This is a micro switch used in the microwave door interlock system. It detects whether the door is properly closed and signals the control board to allow or prevent microwave operation. Replace this switch if the microwave won't start, runs with the door open, or if the door latch clicks but the unit doesn't respond.

Oven not heating or preheating slowly? This bake element restores proper baking temperatures. Easy DIY repair—remove door, disconnect wires, swap part.

The Bulb is an OEM part for Bosch ovens. This component provides illumination inside the oven, allowing you to easily monitor the cooking process without opening the door and losing heat.

Causes of a bad bulb can include filament burnout due to extended use, electrical issues that cause power surges, or physical damage from accidental impacts. 

Symptoms of a bad bulb include:

• The oven light not turning on
• Flickering light inside the oven
• Dim or uneven lighting
• The bulb appearing visibly damaged or burnt out

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

Replacement inner glass panel for oven doors. Installs between door layers. Needed when original glass is cracked, chipped, or shattered from impact.

Oven door gasket seals the cavity to retain heat during cooking. Replace when torn, compressed, or allowing hot air leaks. Confirm fit by model number.

Oven won't heat or shuts off during use? This thermal fuse cuts power when temperature exceeds safe limits. Moderate DIY repair with multimeter testing.

If your oven won't start or runs with the door open, this door interlock switch detects proper closure and latching. DIY repair in under an hour.

This is a thermal fuse designed to protect the microwave's electrical circuit from overheating. It acts as a safety device that breaks the circuit if internal temperatures exceed safe limits. Replace this fuse if your microwave suddenly stops working or loses all power, as a blown thermal fuse is a common cause of a completely dead unit.

Microwave not heating? This magnetron generates the microwaves that cook your food. Common fix when your microwave runs but won't heat food properly.

This is a high voltage capacitor used in the microwave's magnetron circuit to store and release electrical energy needed to power the magnetron tube. It works together with the diode and transformer to generate the high voltage required for microwave cooking. Replace this capacitor if the microwave runs but does not heat food, makes a loud buzzing or humming noise, or if diagnostic testing shows the capacitor has failed. Warning - capacitors can retain a lethal charge even when the appliance is unplugged, so discharge it safely before handling.

Replacement mounting nut for securing internal oven and range components. Needed when original fastener is stripped, missing, or damaged during repair work.

This latch control board is the door latch circuit board that detects and secures the door closure so the appliance can start and run. Replaces a failed latch board to restore proper door-detection and lock signaling. What it does:

• Detects door closure and sends the lock/unlock signal to the main control
• Engages the door latch/lock circuit so the unit can begin its cycle
• Prevents operation when the door is not properly secured
• Can resolve symptoms like the appliance not starting or not recognizing a closed door

• Disconnect power before beginning any repair to avoid shock or damage
• Handle the board by its edges and avoid contact with component leads
• Verify connectors and door latch alignment before final reassembly

Mounting screw for ranges and cooktops. Secures panels, brackets, and components during installation. Replace if lost, stripped, or damaged.

Display signal wire harness for ovens and ranges. Connects control board to display panel. Replace if wires are damaged, connectors broken, or harness is worn.