Bosch Washer WFO1260IT Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Replace your washer door seal if you notice water leaking during wash cycles. This rubber boot creates a watertight barrier between drum and door. Confirm fit with your model number.

Secures the door boot seal to the washer front panel, preventing leaks. Replace if broken or when installing a new door seal for proper fit.

Wire clamp spring that secures the door boot to the washer's front panel opening. Replace if broken, stretched, or missing to keep the seal properly seated.

This valve magnet is the solenoid actuator used to open and close a dishwasher water/control valve, restoring proper water flow for filling and cycle operation. It replaces a failed or weak magnet to help the valve respond correctly. What it does:

• Converts electrical signal into linear motion to operate the dishwasher valve
• Restores valve opening and closing when a worn or stuck magnet causes fill or circulation issues
• Commonly used when dishwasher won't fill, stops mid-cycle, or shows related valve/fill errors
• Works with the valve body; does not include seals or the full valve assembly

• Disconnect power and shut off the water supply before beginning service
• Replace with the matching OEM magnet and ensure proper seating on the valve body
• Keep terminals dry and secure electrical connections; inspect gaskets and valve body for damage

Adjustable leveling foot that installs on the bottom of your washer to provide stable support. Replace when cracked, worn, or missing to restore balance.

Front drum motor mounting bushing for washers. Supports the drum shaft for smooth rotation. Replace if worn, cracked, or causing misalignment issues.

Replacement holder for your washer. Secures internal components in place. Order a new holder if your original is cracked, broken, or missing.

Secures the drum pulley to the washer's drive system. Replace this bolt if it's stripped, missing, or loose to properly fasten the pulley assembly.

Secures rotating components in your washer to prevent movement and vibration. Replace if parts feel loose or noisy. Confirm fit with your model number.

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

Connects your washer to the household water supply. Replace if hose is cracked, leaking, worn, or damaged to prevent water damage and ensure proper fill.

Fix excessive noise or drum not spinning issues with this washer drum assembly. Solves problems with misaligned or damaged drums during wash cycles.

Water pooling under your washer? A cracked or clogged drain reservoir housing disrupts wastewater flow. This repair restores proper drainage.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

Coupling that connects the program knob to the timer mechanism on your washer. Replace if cracked, stripped, broken, or missing for proper cycle selection.