Bosch Refrigerator B30IR905SP Parts

This genuine replacement control panel restores the appliance's front console, giving you back clear controls and a finished appearance. It lets the control interface work properly so you can select cycles and settings with confidence. What it does:

• Replaces a cracked, warped, or unresponsive front console panel
• Provides a stable mounting surface for buttons, touchpads, and display elements
• Helps prevent moisture and debris from reaching internal controls
• Addresses symptoms like loose or damaged console trim and impaired button access

• Disconnect power to the appliance before starting any work
• Handle carefully to avoid scratching the finished surface during installation
• May require removal of outer door or console trim panels for access; follow factory service instructions
• If the underlying control or touchpad is damaged, replace both components to restore full function

This condenser coil assembly removes heat from the refrigerant so your refrigerator can maintain proper cooling. Replaces a worn or damaged condenser to help restore normal compressor cycling and heat dissipation. What it does

• Dissipates heat from refrigerant after compression to support the cooling cycle.
• Helps maintain proper compressor operation and efficient cooling performance.
• A damaged or clogged condenser can cause longer run times, higher energy use, or reduced cooling.
• Restoring a functioning condenser can reduce compressor stress and temperature-related issues.

• One condenser coil assembly.

• Disconnect power to the appliance before starting any repair.
• Replacing this condenser may require access to sealed refrigerant lines; use a certified HVAC technician.
• Handle carefully to avoid bending fins or damaging tubing; wear gloves to protect against sharp edges.
• Verify all connections are secure and check for leaks or unusual noises after reassembly.

This foam piece is an insulation/cushioning component that protects nearby parts and reduces vibration and noise. It helps keep panels and components from rubbing or contacting each other during operation. What it does

• Cushions components to prevent metal-on-metal contact and wear
• Dampens vibration and can reduce rattling noises
• Separates and protects wires, hoses, or panels from abrasion
• Maintains spacing/isolation where factory foam was installed

• One foam piece

• Disconnect power to the appliance before starting any service
• Remove panels or access covers as needed to reach the foam location
• Fit the foam in the original position and orientation; trim only if explicitly required by the OEM