Bosch Refrigerator B30IR905SP Parts

This spindle is the drum shaft that supports and centers the washer/dryer drum, helping it spin smoothly for normal wash and dry cycles. It restores drum alignment and reduces wobble when worn or damaged. What it does:

• Supports the appliance drum and connects it to the drive/bearing assembly
• Keeps the drum centered to allow smooth, balanced rotation
• Helps prevent rubbing, excessive vibration, and noise caused by a worn shaft
• Works with the drum bearing and mounting hardware to maintain drum stability

• One replacement spindle

• Recommended for technicians or experienced DIYers
• Disconnect power and water supply before starting work
• Inspect bearings, seals, and mounting hardware; replace any worn components for reliable operation
• Use proper tools and torque specifications from the OEM to avoid damage

This fixture is a replacement mounting bracket designed to secure components inside the appliance, restoring proper alignment and stable support. Use when a broken or loose bracket causes parts to shift or rattle during operation. What it does:

• Secures internal components to maintain alignment and prevent movement
• Reduces rattling, vibration, or scraping noises caused by loose or damaged mounts
• Restores correct positioning of connected parts so assemblies operate smoothly
• Helps prevent further wear or damage from improperly supported components

• One mounting fixture/bracket as shown

• Turn off and unplug the appliance (or disconnect power) before starting any repair
• Remove surrounding panels as needed to access the mounting location; keep track of screws and fasteners
• Inspect mating parts and fasteners for damage; replace any stripped screws or broken clips

This foam piece is an insulation/cushioning component that protects nearby parts and reduces vibration and noise. It helps keep panels and components from rubbing or contacting each other during operation. What it does

• Cushions components to prevent metal-on-metal contact and wear
• Dampens vibration and can reduce rattling noises
• Separates and protects wires, hoses, or panels from abrasion
• Maintains spacing/isolation where factory foam was installed

• One foam piece

• Disconnect power to the appliance before starting any service
• Remove panels or access covers as needed to reach the foam location
• Fit the foam in the original position and orientation; trim only if explicitly required by the OEM