Bosch Refrigerator B36IT800NP Parts

Freezer not defrosting or excessive frost buildup? This evaporator defrost heater melts ice during defrost cycles to restore proper cooling and airflow.

Protective housing cover for refrigerator internal components. Shields parts from debris and moisture. Replace when cracked, broken, or missing.

This fixture is the OEM replacement mounting piece designed to secure internal components and restore proper alignment and support. It helps keep parts stable for reliable operation and reduces noise caused by loose hardware. What it does:

• Secures internal panels or components to the appliance frame to prevent movement
• Restores proper alignment to reduce rubbing, vibration, or rattling noises
• Provides the correct mounting point for linked components to operate as intended
• Replaces damaged or missing fixtures that can cause part instability or failure

• Recommended for users comfortable with basic disassembly; unplug the appliance before starting.
• Keep fasteners and surrounding parts organized during removal to ensure correct reassembly.
• Inspect mating surfaces for damage or wear; replace adjacent hardware if needed.

Replacement scraper for upright freezers. Restores proper surface contact and clearance when worn or damaged. Verify compatibility with your model.

Door hinge for refrigerators and freezers. Mounts between the cabinet and door to support proper swing and alignment. Replace if cracked or worn.

Replace a cracked, broken, or missing light fixture in your refrigerator or freezer. This interior fixture installs in the fresh food or freezer compartment.

Secures hoses, wires, and small assemblies inside your refrigerator. Replace if cracked, broken, or missing to restore proper routing and stability.

Mounting bracket fixture secures internal components inside your refrigerator. Replace if broken, cracked, or worn to restore proper alignment and fit.

Replaces broken or missing access cap cover on your refrigerator. Shields internal components from dirt and moisture while maintaining clean appearance.

Genuine replacement mounting screw for securing panels and components. Restores proper fit when original hardware is lost, stripped, or damaged during repairs.

This is an electrical on/off switch used to control power to an appliance circuit. It replaces a failed switch so controls respond normally and the appliance can be powered on and off safely. What it does

• Opens and closes an electrical circuit to enable or disable appliance power or a specific control function
• Commonly replaces a worn, stuck, or unresponsive switch that prevents controls or lights from operating
• Can resolve symptoms like no power to a control, intermittent operation, or a button that won't actuate
• Designed to mate with the appliance's existing wiring and mounting points

• One electrical on/off switch

• Disconnect power to the appliance at the breaker or unplug before working on wiring
• Verify proper wire locations and secure all terminal connections; replace only with the exact part specified by the manufacturer
• Handle the part carefully to avoid bending terminals or damaging the switch actuator

Decorative trim strip that covers the edge of your refrigerator door panel. Replaces cracked, missing, or worn trim to restore a clean, finished look.

This LED diode is a small indicator light used on appliance control or display circuits. Replacing a failed or dim LED restores clear, reliable visual feedback for power, cycle status, or alerts so the interface is easy to read.

• Provides low-voltage illumination for indicators or backlighting on the user interface or PCB
• Helps signal power, program progress, or warnings
• Typical failure symptoms: no light, dim/flickering light, or intermittent operation
• Physical damage to the LED lens or leads can also indicate replacement is needed

• Disconnect power at the breaker or unplug the appliance before servicing
• Access the control panel or board; note polarity/orientation marks and match them during installation
• Use ESD protection; some applications are board-mounted and may require soldering
• Test operation before reassembling the appliance