Bosch Wall Oven HBN5460 Parts

Oven not heating evenly or taking too long to preheat? A faulty blower wheel disrupts air circulation. This fan wheel restores proper airflow.

This metal mounting bracket secures internal components and panels to restore proper alignment and reduce rattling. It's a straightforward replacement part that helps keep appliance panels and assemblies firmly in place for reliable operation. What it does:

• Provides a secure attachment point for panels or internal assemblies to prevent movement and vibration
• Helps correct alignment issues that can cause rubbing, gaps, or noise
• Restores the original fit where a bent, cracked, or missing bracket caused loose parts
• Works with the appliance's existing fasteners and mounting points

• Remove power and, if applicable, disconnect the appliance from water before beginning work
• Use the factory fasteners or OEM replacement screws to secure the bracket in the original location
• Verify alignment of the attached panel or assembly before fully tightening fasteners

Replace your wall oven's broken or snapped door bracket. This mounting bracket secures the lower oven door panel and attaches door clips for proper alignment.

Protective cap seals exposed openings on wall ovens to prevent dirt and moisture damage. Replace if cracked, missing, or loose. Verify fit with model number.

This is the inner glass panel that sits inside the oven door assembly. It helps insulate the oven cavity and keeps heat from escaping through the door. Replace this panel if it is cracked, shattered, or has visible damage, which can cause heat loss and uneven cooking temperatures.

Replace your wall oven door seal gasket to restore airtight closure and prevent heat loss. Maintains proper sealing for efficient cooking. Confirm fit by model.

Seals unused ports in your wall oven to prevent moisture and debris entry. Replace if missing, damaged, or leaking. Verify fit with your model number.

This is a metal trim plate that frames the oven door, providing a finished appearance and structural support around the door's outer edge. It helps secure the door glass and inner panel in place. Replace this part if the trim is cracked, bent, warped, or if the door panels are separating or not sitting flush.

Decorative trim plate that covers gaps around your wall oven's control or access area. Replace if cracked, broken, or missing to restore a clean finish.

Fix a damaged or worn oven door interior with this inner door panel. Restores structural support, provides mounting for hardware, and protects components.

Secures trims and seals panels against dust and vibration. Replace when adhesive weakens or components loosen. Confirm fit with your model number.

Replace a cracked, discolored, or missing light reflector in your wall oven. Installs behind the oven light bulb to direct illumination into the cavity.

Secures wall oven panels and components in place. Replace this mounting bracket when the original is broken, bent, or missing, causing loose panels or misalignment.

Replacement washer for electric wall ovens. Installs between components to provide secure spacing and prevent wear. Order if original is missing, damaged, or worn.