Bosch Wall Oven HBN5460 Parts

Fix an oven that won't reach set temperature or shows inaccurate readings. This temperature sensor monitors heat levels for proper cooking performance.

Wall oven display module controls oven settings and shows temperature readings. Replace when screen goes blank, displays partially, or won't save settings.

This meat probe sensor is a temperature-sensing device that inserts into food while it cooks in the oven, allowing the oven to monitor the internal temperature and automatically stop cooking when the target temperature is reached. It connects to a jack inside the oven cavity via a heat-resistant cable. Replace this probe if your oven no longer reads the food temperature accurately, displays a probe error code, or if the cable or tip is visibly damaged.

Uneven baking or slow heating in convection mode? A failed convection fan motor stops hot air circulation. Moderate DIY repair restores even cooking.

Factory fixing kit with mounting hardware to secure panels, brackets, or trim on your wall oven. Replaces worn, missing, or damaged fasteners for alignment.

Interior light bulb illuminates your wall oven cavity so you can monitor cooking without opening the door. Replace when bulb burns out or flickers.

This is a metal rack that slides into the guide rails inside the oven cavity to support cookware and baking dishes at various heights. It allows for proper heat circulation around food for even cooking. Replace this rack if it is warped, bent, rusted, or no longer slides smoothly on the oven's support rails.

Replace your wall oven door latch if the door won't stay closed, the oven won't start, or cycles are interrupted. Restores proper door closure and locking.

This metal mounting bracket secures internal components and panels to restore proper alignment and reduce rattling. It's a straightforward replacement part that helps keep appliance panels and assemblies firmly in place for reliable operation. What it does:

• Provides a secure attachment point for panels or internal assemblies to prevent movement and vibration
• Helps correct alignment issues that can cause rubbing, gaps, or noise
• Restores the original fit where a bent, cracked, or missing bracket caused loose parts
• Works with the appliance's existing fasteners and mounting points

• Remove power and, if applicable, disconnect the appliance from water before beginning work
• Use the factory fasteners or OEM replacement screws to secure the bracket in the original location
• Verify alignment of the attached panel or assembly before fully tightening fasteners

Fix intermittent power or component failure with this range socket electrical connector. Restores secure wiring connections in electric and gas ranges.

Replace your wall oven's broken or snapped door bracket. This mounting bracket secures the lower oven door panel and attaches door clips for proper alignment.

Protective cap seals exposed openings on wall ovens to prevent dirt and moisture damage. Replace if cracked, missing, or loose. Verify fit with model number.

Mounting screw for ranges and cooktops. Secures panels, brackets, and components during installation. Replace if lost, stripped, or damaged.

90-degree connector cable for ovens and cooktops. Replaces damaged, frayed, or missing connectors. Essential for secure electrical connections.

Seals unused ports in your wall oven to prevent moisture and debris entry. Replace if missing, damaged, or leaking. Verify fit with your model number.