Bosch Dishwasher SHV88PZ53N Parts

Threaded nut secures components to bolts inside your dishwasher. Replace if stripped, missing, or loose to restore proper clamping force. Confirm fit.

This replacement spring restores proper tension in the specific mechanism it supports, helping the connected component operate smoothly. A worn or broken spring can cause weak action, poor latching, or parts that won't return or stay in position.

• Provides controlled tension/return force for moving parts per your model's design
• Helps doors, lids, latches, or dispenser mechanisms open/close or release reliably
• Symptoms of failure can include weak or uneven tension, components not staying shut/open, or sluggish operation
• Replace if the spring is stretched, broken, deformed, corroded, or missing

• Disconnect power and shut off water supply before servicing
• Note the spring's orientation and anchor points; take a photo for reference
• Use needle-nose pliers for removal/installation and avoid over-stretching
• If your model uses paired springs, replace both to maintain balanced tension

Service tool set for dishwasher installation and repairs. Includes specialty drivers and tools for accessing fasteners and making adjustments. Needed for proper servicing.

Replace your dishwasher's cap cover plug to seal access ports and protect against moisture and debris. Restores a clean finish. Confirm fit with your model.

Lower housing that forms the structural base of your dishwasher. Replace when the original case is cracked, warped, or damaged to restore stability.

Molded plastic duct at top of dishwasher that vents steam and vapors during wash and dry cycles. Replace if cracked, broken, or missing components.

Single Torx T20 screw secures dishwasher panels, brackets, and trim. Replace missing, stripped, or damaged fasteners to keep components tight.

Secures internal dishwasher components to maintain proper alignment and reduce movement. Replace when original bracket is cracked, deformed, or worn.

Secures internal components and panels with a threaded anchor point. Replace when original stud is missing, cracked, or stripped for stable mounting.

Installation hardware set for dishwashers. Includes mounting brackets, bolts, and screws to secure dishwasher into cabinetry. Replace missing or damaged parts.

Mounting holder that secures internal dishwasher components in place. Replace if cracked, broken, or missing to restore proper support and alignment.

Inner door panel for dishwashers. Serves as protective barrier between interior tub and outer door. Replace if cracked, warped, or damaged to restore seal.

Factory mounting screw secures panels, brackets, and internal components in your dishwasher. Replace missing, stripped, or damaged screws during repair.

Fix cloudy dishes and hard water spots with this water softener regeneration valve. Restores proper brine flow during recharge cycles for cleaner dishes.

Fix loose or rattling dishwasher components with this holder retainer. Secures parts in position to prevent movement and restore quiet operation.

This is a small rubber seal that fits on the water softener cap inside the dishwasher, creating a watertight barrier to prevent leaks. It ensures the water softener compartment remains properly sealed during wash cycles. Replace this seal if you notice water leaking from the softener cap area or if the rubber has become worn, cracked, or no longer provides a tight fit.