Bosch Dishwasher SMD69M54EU Parts

Channels wastewater from your dishwasher to the household drain. Replace if brittle, cracked, clogged, or leaking to restore proper drainage.

Seals the sump area to prevent leaks and ensure proper water circulation and drainage. Replace if cracked, warped, or missing. Verify fit with your model.

Dishes not getting clean? A cracked or clogged spray arm prevents proper water distribution. This replacement part restores even spray coverage.

Detergent releasing too early or leaking from the dispenser? This seal creates a watertight barrier to prevent premature dissolution. Easy 10-minute fix.

This replacement screw secures panels, brackets, and internal parts in your appliance for a tight, rattle-free fit. Use it to replace lost, stripped, or corroded hardware and keep components properly fastened.

• Fastens components to the appliance frame or assemblies
• Replaces a missing, stripped, or rusted original screw
• Helps reduce rattling or vibration from loose hardware
• Restores proper alignment of panels or brackets

• Disconnect power and shut off water before servicing
• Refer to your model's parts diagram to locate and place
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening

Dishwasher door seal creates a watertight barrier around the tub opening. Replace if you notice leaks, moisture escaping, or visible cracks. Confirm fit with your model number.

This switch is mounted on the dishwasher frame and detects when the door is properly closed to allow the wash cycle to begin. Replace it if your dishwasher won't start even with the door firmly closed, or if it stops mid-cycle unexpectedly.

Dishwasher rack insert secures components within the dish rack assembly. Replace if cracked, broken, or missing to restore proper alignment and fit.

Fix E4 water flow errors in your dishwasher with this flow meter sensor. Monitors water volume to ensure proper fill levels during wash cycles.

Replaces the rotating spray arm shower head in your dishwasher's upper rack. Install a new one if yours is cracked, broken, or keeps falling off the tube.

Secures the dishwasher sump or sump cover to the tub for a tight, leak-resistant seal. Replace if missing, stripped, or damaged to restore stability.

Original installation hardware set for dishwashers. Includes mounting fasteners and brackets to secure components and panels. Replace worn or missing hardware.

Fix incomplete cycles or poor cleaning caused by a faulty temperature sensor. This NTC sensor monitors water temperature to ensure proper heating and cycle timing.

The Spray Head is an OEM replacement part for Bosch dishwashers. It directs pressurized water along the dish racks, targeting every inch of dishware and cookware. Consistent coverage cleans thoroughly without waste.   

Symptoms of a bad spray head can include clogged nozzles, inconsistent patterns, or spray heads that do not oscillate and rotate properly through cycles. Mineral deposits pose blockage risks over time.

Causes of a bad spray head include:

• Uneven or skipped areas of spray coverage inside the machine
• Rotating/oscillating mechanisms that jam or continuously stick  
• Nozzles fully or partially blocked reducing water pressure
• Head assembly detaching from water tub wall or bracket

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

Creates a watertight barrier between dishwasher components. Replace if cracked, flattened, or leaking to prevent drips. Verify fit with your model.

Replacement trim insert for dishwasher racks. Secures panels and tines, closes gaps for proper alignment. Needed when original is cracked, broken, or missing.