Bosch Dishwasher SMD85M22DE Parts

Seals the sump area to prevent leaks and ensure proper water circulation and drainage. Replace if cracked, warped, or missing. Verify fit with your model.

Detergent releasing too early or leaking from the dispenser? This seal creates a watertight barrier to prevent premature dissolution. Easy 10-minute fix.

This replacement screw secures panels, brackets, and internal parts in your appliance for a tight, rattle-free fit. Use it to replace lost, stripped, or corroded hardware and keep components properly fastened.

• Fastens components to the appliance frame or assemblies
• Replaces a missing, stripped, or rusted original screw
• Helps reduce rattling or vibration from loose hardware
• Restores proper alignment of panels or brackets

• Disconnect power and shut off water before servicing
• Refer to your model's parts diagram to locate and place
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening

Dishwasher door seal creates a watertight barrier around the tub opening. Replace if you notice leaks, moisture escaping, or visible cracks. Confirm fit with your model number.

This switch is mounted on the dishwasher frame and detects when the door is properly closed to allow the wash cycle to begin. Replace it if your dishwasher won't start even with the door firmly closed, or if it stops mid-cycle unexpectedly.

Dishwasher rack insert secures components within the dish rack assembly. Replace if cracked, broken, or missing to restore proper alignment and fit.

Fix E4 water flow errors in your dishwasher with this flow meter sensor. Monitors water volume to ensure proper fill levels during wash cycles.

Replaces the rotating spray arm shower head in your dishwasher's upper rack. Install a new one if yours is cracked, broken, or keeps falling off the tube.

Secures the dishwasher sump or sump cover to the tub for a tight, leak-resistant seal. Replace if missing, stripped, or damaged to restore stability.

Original installation hardware set for dishwashers. Includes mounting fasteners and brackets to secure components and panels. Replace worn or missing hardware.

Fix incomplete cycles or poor cleaning caused by a faulty temperature sensor. This NTC sensor monitors water temperature to ensure proper heating and cycle timing.

Creates a watertight barrier between dishwasher components. Replace if cracked, flattened, or leaking to prevent drips. Verify fit with your model.

Replacement trim insert for dishwasher racks. Secures panels and tines, closes gaps for proper alignment. Needed when original is cracked, broken, or missing.

This genuine replacement bearing supports the washer drum for smooth, stable rotation and helps reduce noise and vibration caused by worn or damaged bearings. Restores proper drum alignment for quieter operation. What it does:

• Supports the inner drum so it spins smoothly and stays aligned
• Reduces grinding, rumbling, squeaking or knocking noises from the drum
• Helps prevent excessive drum wobble that can damage seals or the tub
• Used when worn bearings cause rough rotation, metal-on-metal noise, or visible drum play

• Disconnect power (and water if applicable) before starting any repair
• Replacing this bearing typically requires partial disassembly of the washer/drum assembly and specialty tools
• Inspect shaft/hub, seals, and surrounding components for wear and replace if damaged

Replacement mounting hardware kit for securing dishwasher panels and components. Includes fasteners and clips to restore proper support and stability.

Connects the dishwasher door hinge to the tension spring to counterbalance door weight. Replace if cable is frayed, broken, or detached from spring.