Bosch Washer WAS24460SA Parts

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

This interference capacitor reduces electrical noise and helps protect the appliance's control circuitry from voltage spikes. It's a direct-replacement noise suppressor used where EMI/RFI filtering is required for reliable operation. What it does:

• Suppresses electromagnetic and radio-frequency interference that can affect controls and electronics
• Helps prevent false signals or erratic behavior caused by electrical noise
• Supports stable operation of motors and electronic control boards
• Can reduce audible electrical noise or interference-related symptoms

• Disconnect power at the breaker before inspecting or replacing the capacitor
• Discharge the capacitor and avoid touching terminals; use insulated tools
• Verify wiring match and polarity before connecting

2 included - Front load

Replace your washer's door boot gasket when you notice leaking, tears, or water pooling around the door. Confirm fit using your model number and revision.

Routes water between washer components. Replace if cracked, worn, or leaking to restore proper water flow and prevent leaks. Confirm fit with your model.

Fix washer overfilling or not filling properly. This pressure sensor monitors water levels during wash cycles. Common repair for fill issues.

Washer won't start or stops mid-cycle? This door lock assembly secures the door during operation, restoring proper locking and cycle completion.

This glass front panel replaces a cracked or damaged outer door surface to restore appearance and protect internal components. It provides the visible exterior surface for the appliance door and keeps the interior sealed from everyday wear. What it does:

• Replaces broken, cracked, or scratched outer door glass to restore the appliance's exterior
• Protects controls and internal layers behind the door from impact and debris
• Restores a smooth, easy-to-clean surface and original appearance
• Helps prevent sharp edges or glass fragments from exposing internal parts

• Handle carefully; wear cut-resistant gloves and eye protection to avoid injury from sharp edges
• Remove power to the appliance before starting any disassembly
• Follow OEM disassembly instructions for removing the door assembly and separating layers—do not force components
• If adhesive or clips are used, replace any damaged fasteners and allow adhesives to cure per manufacturer guidance

Fix washer not filling or slow fill with this inlet hose. Stops leaks at connection points and restores proper water delivery. Direct-fit replacement.

13mm wrench designed for washer installation and maintenance. Used to remove shipping bolts and adjust leveling legs. Replace if lost or damaged.

Siphon device for washer dispenser systems. Replaces cracked, broken, or missing siphon components that affect detergent flow and dispensing.

Replace your washer's program selector knob if it's cracked, broken, or missing. This control knob installs on the front panel to select wash cycles.

Replacement fixture assembly that secures internal washer components. Needed when original is cracked, broken, or worn, causing misalignment or rattling.

Fix washer electrical issues with this cable harness. Solves control panel errors, display failures, and connectivity problems. Direct fit replacement part.

Fix washer control issues with this cable harness. Solves problems with unresponsive controls, display errors, or cycle malfunctions. Moderate DIY repair.

Fix a washer that won't start, has no display, or shows error codes with this cable harness. Connects electrical components to the control board.