Bosch Washer WFL165KIT Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Secures the door boot seal to the washer front panel, preventing leaks. Replace if broken or when installing a new door seal for proper fit.

Wire clamp spring that secures the door boot to the washer's front panel opening. Replace if broken, stretched, or missing to keep the seal properly seated.

This valve magnet is the solenoid actuator used to open and close a dishwasher water/control valve, restoring proper water flow for filling and cycle operation. It replaces a failed or weak magnet to help the valve respond correctly. What it does:

• Converts electrical signal into linear motion to operate the dishwasher valve
• Restores valve opening and closing when a worn or stuck magnet causes fill or circulation issues
• Commonly used when dishwasher won't fill, stops mid-cycle, or shows related valve/fill errors
• Works with the valve body; does not include seals or the full valve assembly

• Disconnect power and shut off the water supply before beginning service
• Replace with the matching OEM magnet and ensure proper seating on the valve body
• Keep terminals dry and secure electrical connections; inspect gaskets and valve body for damage

Adjustable leveling foot that installs on the bottom of your washer to provide stable support. Replace when cracked, worn, or missing to restore balance.

Front drum motor mounting bushing for washers. Supports the drum shaft for smooth rotation. Replace if worn, cracked, or causing misalignment issues.

This is a rubber bellow gasket that seals the gap between the front-load washer door and the outer tub, preventing water from leaking during the wash and spin cycles. It flexes to accommodate the movement of the drum while maintaining a watertight seal. Replace this part if you notice water leaking from around the door, visible tears or mold buildup on the rubber that cannot be cleaned, or a musty odor coming from the washer.

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

Replacement holder for your washer. Secures internal components in place. Order a new holder if your original is cracked, broken, or missing.

Secures the drum pulley to the washer's drive system. Replace this bolt if it's stripped, missing, or loose to properly fasten the pulley assembly.

This cover protects internal components and provides a finished appearance. Replace if cracked, broken, or missing to restore proper enclosure.

Fix excessive noise or drum not spinning issues with this washer drum assembly. Solves problems with misaligned or damaged drums during wash cycles.

Secures rotating components in your washer to prevent movement and vibration. Replace if parts feel loose or noisy. Confirm fit with your model number.

This fastening ring secures mating appliance components by locking parts in place to prevent movement or separation during operation. It's a simple yet essential hardware piece that helps maintain proper alignment and reliable function. What it does

• Holds mating parts together to prevent wobble, vibration, or dislocation
• Keeps seals and assemblies properly seated to reduce noise and misalignment
• Helps maintain correct component spacing for smooth operation
• Commonly replaced when the original ring is bent, worn, or missing

• Designed for use with compatible OEM assemblies; follow for correct placement
• Inspect mating surfaces and replace any damaged clips, seals, or gaskets before reassembly
• Use proper tools to avoid deforming the ring during installation; do not force into place
• Disconnect power and follow safety procedures before servicing the appliance