Bosch Washer WFL2090 Parts

This is a rubber bellow gasket that seals the gap between the front-load washer door and the outer tub, preventing water from leaking during the wash and spin cycles. It flexes to accommodate the movement of the drum while maintaining a watertight seal. Replace this part if you notice water leaking from around the door, visible tears or mold buildup on the rubber that cannot be cleaned, or a musty odor coming from the washer.

Replacement holder for your washer. Secures internal components in place. Order a new holder if your original is cracked, broken, or missing.

Secures the drum pulley to the washer's drive system. Replace this bolt if it's stripped, missing, or loose to properly fasten the pulley assembly.

Shipping bolt for front load washers. Secures the drum during transport. Replace if lost, damaged, or missing when moving or reinstalling your washer.

Secures the front counterweight to the washer drum. Replace if strap is cracked, broken, worn, or missing to restore proper weight distribution.

Washer not filling with cold water or filling slowly? This cold water inlet valve controls water flow into your washer. Moderate DIY repair.

Replace your washer's rubber sealing ring to stop water leaks and maintain a tight seal between parts. Install when you notice dripping or moisture buildup.

Transit bolt for washer drum stabilization during shipping and moving. Replace if lost, stripped, or damaged when relocating your washing machine.

Delivers hot water from your heater to the washer. Replace if leaking, cracked, or damaged to prevent water damage. Verify fit with your model number.

Replaces worn or broken washer drive belt that connects motor to drum. If drum won't spin during wash or spin cycles, this belt restores operation.

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

Replace worn washer drum bearings to restore quiet operation and eliminate grinding, squealing, or wobbling. Supports drum shaft for smooth rotation. Verify fit with your model number before ordering.

This spring-tank is the replacement spring assembly used to restore proper door balance and movement. It helps the appliance door open and close smoothly and prevents sudden drops or heavy lifting. What it does

• Provides counterbalance tension for the appliance door to control opening and closing motion
• Reduces sagging or slamming of the door caused by worn or broken springs
• Restores smooth, even movement when the door feels heavy or uneven
• Works as a direct-fit replacement when the original spring assembly fails

• One spring-tank

• Disconnect power and water to the appliance before starting any repair
• Handle spring components carefully; springs are under tension and can cause injury if released unexpectedly
• Use proper tools and follow manufacturer instructions or a service manual for safe removal and installation