Bosch Washer WFL2090 Parts

Washer not filling with cold water or filling slowly? This cold water inlet valve controls water flow into your washer. Moderate DIY repair.

13mm wrench designed for washer installation and maintenance. Used to remove shipping bolts and adjust leveling legs. Replace if lost or damaged.

Replace your washer's rubber sealing ring to stop water leaks and maintain a tight seal between parts. Install when you notice dripping or moisture buildup.

If detergent isn't dispensing properly or the drawer leaks, the dispenser case may be cracked or clogged. This replacement part restores function.

Fix washer overfilling or not filling properly with a new float assembly. This part regulates water level in your washing machine. Simple repair.

Transit bolt for washer drum stabilization during shipping and moving. Replace if lost, stripped, or damaged when relocating your washing machine.

The Cold Water Inlet Hose is an OEM replacement part for Bosch washing machines. It serves as a flexible supply line that delivers cold water from an external plumbing source directly to the washer. This hose plays an important role in providing a balanced mix of hot and cold water flow into the unit.

Symptoms of a bad cold water inlet hose include:

• Fluctuations in water temperature during cycles  
• Issues with certain temperature settings like warm or cold not operating properly
• Visible cracking, kinking, or leaking along the hose body
• No water flow or pressure at the cold supply 

Causes of a failed cold water inlet hose can be mineral deposits clogging the line, natural wear and tear over time, or physical damage from crushing or abrasive surfaces compromising its integrity.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore washing machine models.

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

This spring-tank is the replacement spring assembly used to restore proper door balance and movement. It helps the appliance door open and close smoothly and prevents sudden drops or heavy lifting. What it does

• Provides counterbalance tension for the appliance door to control opening and closing motion
• Reduces sagging or slamming of the door caused by worn or broken springs
• Restores smooth, even movement when the door feels heavy or uneven
• Works as a direct-fit replacement when the original spring assembly fails

• One spring-tank

• Disconnect power and water to the appliance before starting any repair
• Handle spring components carefully; springs are under tension and can cause injury if released unexpectedly
• Use proper tools and follow manufacturer instructions or a service manual for safe removal and installation

This eco hose sump assembly manages water drainage and filtration in the dishwasher's lower section. Replace if water doesn't drain properly after cycles, you notice standing water in the bottom, or error codes related to drainage appear.

Fix a washer that won't stop filling or overfills during cycles. This water level pressure switch senses and regulates fill levels to restore proper operation.

Secures rotating components in your washer to prevent movement and vibration. Replace if parts feel loose or noisy. Confirm fit with your model number.

Washer won't spin or agitate? The drive motor powers the drum rotation during wash and spin cycles. Direct drive replacement restores function.

This is a door hook or holder that latches the dryer door securely in the closed position during operation. It engages with the door strike or catch to keep the door from opening while the dryer is running. Replace this part if the dryer door won't stay closed, pops open during a cycle, or if the hook is visibly cracked or broken.

Fix excessive noise or drum not spinning issues with this washer drum assembly. Solves problems with misaligned or damaged drums during wash cycles.