Bosch Washer WFL242YNL Parts

Secures the drum pulley to the washer's drive system. Replace this bolt if it's stripped, missing, or loose to properly fasten the pulley assembly.

Secures the front counterweight to the washer drum. Replace if strap is cracked, broken, worn, or missing to restore proper weight distribution.

Fix a washer that won't spin or agitate with this drive belt. Connects the motor to the drum for proper rotation. DIY-friendly repair in about 1 hour.

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

Replace worn washer drum bearings to restore quiet operation and eliminate grinding, squealing, or wobbling. Supports drum shaft for smooth rotation. Verify fit with your model number before ordering.

This flexible drain hose routes wastewater from the dishwasher tub to the drain pump or household drain, helping remove used water after a cycle. It replaces a damaged or leaking hose to restore proper draining. What it does

• Carries wastewater from the dishwasher to the drain pump or disposal
• Stops leaks and prevents water pooling when the original hose is cracked or split
• Helps resolve slow or incomplete draining caused by a compromised hose
• Fits the factory hose connections and follows the cabinet routing to avoid kinks

• One flexible drain hose

• Disconnect power and turn off water before beginning any repair
• Remove the lower access panel or toe kick to reach hose connections
• Inspect and follow the original routing; avoid sharp bends or kinks that restrict flow
• Secure hose with appropriate clamps and check all connections for leaks after testing

Fix a washer that won't stop filling or overfills during cycles. This water level pressure switch senses and regulates fill levels to restore proper operation.

Secures rotating components in your washer to prevent movement and vibration. Replace if parts feel loose or noisy. Confirm fit with your model number.

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

Connects your washer to the household water supply. Replace if hose is cracked, leaking, worn, or damaged to prevent water damage and ensure proper fill.

This cover protects internal components and provides a finished appearance. Replace if cracked, broken, or missing to restore proper enclosure.

Washer outer drum gasket seals the drum to prevent leaks. Replace if you notice water leaking during cycles or dampness around the drum area. Verify fit with your washer's model number before ordering.

Water pooling under your washer? A cracked or clogged drain reservoir housing disrupts wastewater flow. This repair restores proper drainage.

This shaft seal fits around the main drive shaft where it passes through the outer tub of the washing machine. It prevents water from leaking out of the tub and into the motor or bearing area. Replace this seal if you notice water dripping from beneath the tub, hear grinding noises during the spin cycle, or find water pooling under the machine.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly