Bosch Washer WFR3268GB Parts

Replacement holder for your washer. Secures internal components in place. Order a new holder if your original is cracked, broken, or missing.

Connects your washer to the household water supply. Replace if hose is cracked, leaking, worn, or damaged to prevent water damage and ensure proper fill.

Secures the drum pulley to the washer's drive system. Replace this bolt if it's stripped, missing, or loose to properly fasten the pulley assembly.

Shipping bolt for front load washers. Secures the drum during transport. Replace if lost, damaged, or missing when moving or reinstalling your washer.

2 included - Front load

13mm wrench designed for washer installation and maintenance. Used to remove shipping bolts and adjust leveling legs. Replace if lost or damaged.

Replace your washer's rubber sealing ring to stop water leaks and maintain a tight seal between parts. Install when you notice dripping or moisture buildup.

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

This flexible drain hose routes wastewater from the dishwasher tub to the drain pump or household drain, helping remove used water after a cycle. It replaces a damaged or leaking hose to restore proper draining. What it does

• Carries wastewater from the dishwasher to the drain pump or disposal
• Stops leaks and prevents water pooling when the original hose is cracked or split
• Helps resolve slow or incomplete draining caused by a compromised hose
• Fits the factory hose connections and follows the cabinet routing to avoid kinks

• One flexible drain hose

• Disconnect power and turn off water before beginning any repair
• Remove the lower access panel or toe kick to reach hose connections
• Inspect and follow the original routing; avoid sharp bends or kinks that restrict flow
• Secure hose with appropriate clamps and check all connections for leaks after testing

This spring-tank is the replacement spring assembly used to restore proper door balance and movement. It helps the appliance door open and close smoothly and prevents sudden drops or heavy lifting. What it does

• Provides counterbalance tension for the appliance door to control opening and closing motion
• Reduces sagging or slamming of the door caused by worn or broken springs
• Restores smooth, even movement when the door feels heavy or uneven
• Works as a direct-fit replacement when the original spring assembly fails

• One spring-tank

• Disconnect power and water to the appliance before starting any repair
• Handle spring components carefully; springs are under tension and can cause injury if released unexpectedly
• Use proper tools and follow manufacturer instructions or a service manual for safe removal and installation

Fix a washer that won't fill properly or has cycle issues with this water flow sensor. Monitors water delivery to ensure correct fill levels during wash cycles.

Secures rotating components in your washer to prevent movement and vibration. Replace if parts feel loose or noisy. Confirm fit with your model number.

Fix washer water level issues with this analog pressure switch. Solves problems with overfilling, underfilling, or incorrect water levels during wash cycles.

This is a door hook or holder that latches the dryer door securely in the closed position during operation. It engages with the door strike or catch to keep the door from opening while the dryer is running. Replace this part if the dryer door won't stay closed, pops open during a cycle, or if the hook is visibly cracked or broken.

Water pooling under your washer? A cracked or clogged drain reservoir housing disrupts wastewater flow. This repair restores proper drainage.