Bosch Dryer WTS86500IT Parts

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

Dryer door seal creates an airtight barrier to retain heat and improve efficiency. Replace if torn, cracked, or causing heat loss. Verify fit with your model.

This inner oven door window provides a clear, heat-resistant viewing panel so you can monitor cooking without opening the door. It restores visibility and helps the door retain heat for more consistent baking and roasting. What it does:

• Replaces a cracked, chipped, or broken oven door window to restore a safe viewing surface
• Prevents heat loss and maintains cooking temperature by sealing the door opening
• Reduces drafts and stops rattling or vibration caused by damaged glass
• Lets you check food progress without opening the door, avoiding temperature drops

• Disconnect power to the appliance and allow the oven to fully cool before servicing
• Wear cut-resistant gloves and safety glasses when handling glass to avoid injury
• Door removal or partial disassembly is often required; follow the oven's service manual
• Inspect door seals and mounting clips and replace any damaged hardware during installation

Replacement rotary program selector knob for your dryer control panel. Restores reliable cycle selection when original is cracked, broken, or missing.

Dryer won't start or stops mid-cycle? A faulty door latch prevents operation. This mechanical lock assembly ensures your door closes and latches securely.

Replacement top lid cover for dryers. Protects internal components and restores finished appearance. Replaces cracked, broken, or missing lids.

This hose connection inlet provides the sealed connection point where the appliance's water inlet hose mates to the valve or tub, restoring a leak-free water feed and reliable flow for normal operation. What it does

• Connects the inlet water hose to the appliance inlet fitting or valve, directing water into the unit
• Creates a sealed joint to prevent drips and leaks at the hose connection
• Replaces cracked, worn, or damaged fittings that can cause visible leaks or reduced water flow
• Helps resolve symptoms such as water pooling under the appliance, continuous dripping, or inlet hose not seating properly

• One hose connection inlet

• Always disconnect power and shut off the water supply before starting work
• Inspect and replace any worn O-rings, gaskets, or clamps when installing this fitting
• Hand-start threads, then tighten clamps or fasteners to secure the hose; avoid over-tightening plastic parts
• After installation, restore water and power and check carefully for leaks during a short test cycle

Small spacer that maintains proper clearance between dryer components. Replace if cracked, missing, or worn to prevent parts from rubbing or misaligning.

Replace your dryer door seal to stop air leaks and improve drying efficiency. Install when you notice tears, gaps, or lint escaping. Verify fit with your model.

Suspension spring for dryer drum support system. Installs between the drum and cabinet to absorb vibration. Replace if stretched, broken, or missing.

Sealing ring creates airtight barrier to prevent leaks in your dryer. Replace when worn or cracked to restore proper seal. Verify fit with your model.