Electrolux Dishwasher GDBE250AW0A Parts

This small check ball sits inside the dishwasher's drain pump or water inlet valve and acts as a one-way valve to prevent water from flowing backward through the system. It ensures water moves in the correct direction during wash and drain cycles. Replace this part if you notice water draining back into the tub after a cycle completes, the dishwasher isn't draining properly, or water is leaking from the pump area.

This replacement screw secures dishwasher components so they stay tight and aligned during operation. Use it to replace missing, rusted, or stripped hardware and restore a solid, rattle-free installation. What it does:

• Fastens compatible parts to the tub, frame, or internal assemblies
• Replaces worn or damaged screws to maintain proper mounting
• Helps reduce rattling or vibration from loose hardware
• Prevents shifting that can affect wash performance or cause leaks, depending on location

• 1 screw

• Disconnect power and shut off water before servicing
• Access the component being secured and remove the damaged or missing screw
• Start threads by hand to avoid cross-threading; do not overtighten, especially into plastic
• Match length and style to the original fastener for correct fit

This genuine replacement bushing supports a rotating shaft or drum, reducing friction and wear to restore smooth, quiet operation. Use it to replace a worn or damaged sleeve that lets parts rub or bind. What it does:

• Guides and cushions a rotating shaft or drum to prevent metal-on-metal contact
• Reduces noise, vibration, and rubbing caused by worn supports
• Helps maintain proper alignment of moving parts for consistent operation
• Prevents accelerated wear of bearings, shafts, and housings

• Disconnect power before starting any repair; follow all safety instructions for your appliance
• Inspect mating shaft and housing for wear; replace damaged components as needed
• Light lubrication may be required only if specified by the manufacturer; do not force parts into place

Replacement mounting screw for dishwashers. Secures trim, panels, brackets, and internal components. Order when fasteners are missing, stripped, or corroded.

Replacement mounting screw for dishwasher panels and components. Secures loose panels, brackets, and trim. Needed when original fasteners are missing, stripped, or worn.

Replacement mounting screw for dishwashers. Secures internal components, panels, and brackets. Order when original screw is stripped, missing, or broken.

Plastic dispenser mounting screw for dishwashers. Secures detergent dispenser assembly to door. Replace if stripped, cracked, or missing.

Secures water or drain hoses to fittings, preventing leaks and loose connections. Replace when hoses slip or drip to restore a tight seal.

Secures the sump assembly and pump seal to prevent leaks and maintain proper water flow. Replace if damaged or during sump repairs. Confirm fit with model.

Replacement mounting screw that secures control switches and switch assemblies to the dishwasher panel. Needed when original hardware is lost or stripped.

Secures dishwasher hoses to prevent leaks and water damage. Replace if loose, cracked, or leaking. Verify fit with your model number before ordering.

Replacement dishwasher door hinge pin that connects the door to the frame. Needed when the original pin is worn, bent, or broken causing door alignment issues.

Protective shield that guards internal dishwasher components from heat and moisture. Replaces cracked, warped, or missing original shields.