Kenmore Refrigerator 106.44022601 (10644022601, 106 44022601) Parts

This door shelf trim replaces the damaged or worn plastic trim that secures and finishes the front edge of a refrigerator door shelf, restoring appearance and helping keep items in place. What it does

• Replaces cracked, broken or missing door-shelf trim that allows items to fall forward
• Restores a finished look to the refrigerator door interior
• Helps retain bottles and containers on the door shelf edge
• Matches OEM fit and mounting points for straightforward replacement

• One door shelf trim piece as shown

• Typically snaps into the front edge of the door shelf; remove the shelf/bin first if needed
• Inspect mounting tabs for damage and replace bin/shelf if tabs are broken
• Use gentle prying with a plastic tool to avoid scratching surrounding surfaces
• Unplug the appliance or disconnect power if working near electrical components or lights

This screw anchor is a small plastic fastener that secures panels and trim on appliances, preventing screws from stripping or pulling out. It provides a reliable anchor point for screws where threaded material is thin or absent. What it does:

• Creates a secure mounting point for screws in sheet metal, plastic or thin panels
• Helps prevent screw looseness, stripping, and parts that shift or rattle
• Commonly used to hold trim, panels, or interior components in place
• Works with compatible screws to distribute load and stabilize attachments

• Use the correct screw size and length; anchors are made for specific screw diameters—do not force oversize screws
• Align anchor in the prepared hole before driving the screw to avoid cracking the anchor or surrounding material
• Hand-start screws until seated, then tighten gradually—do not overtighten to prevent stripping or damage
• Disconnect power and follow appliance safety procedures before accessing internal panels

A roll pin (spring pin) that secures rotating or sliding components by fitting into matched holes to hold shafts, levers, or brackets in place. Replaces a worn or damaged pin to restore proper mechanical engagement. What it does:

• Holds shafts, levers or hinges in position by expanding into drilled holes for a snug, vibration-resistant fit
• Keeps pulleys, rollers, or linkages from moving out of alignment or sliding off their shafts
• Common symptom: loose or wobbling pulley, lever, or shaft where the retaining pin is worn or broken
• Common symptom: noisy or intermittent operation caused by a pin that no longer secures moving parts

• Inspect mating holes and shaft for wear; replace pin with correct size to ensure secure fit
• Use appropriate pliers or a pin punch and hammer to drive the pin in or out; support the assembly to avoid damage
• Wear eye protection when installing or removing roll pins—pins can snap or fly out under force
• If pin is difficult to remove or install, consider using penetrating oil or heating only per OEM guidance

Color: White. Size: 1 qt. can. Acrylic appliance paint.

Size: 8-32 x 1/4 inch.

Color: Apollo Gray