Kenmore Refrigerator 106.56682500 (10656682500, 106 56682500) Parts

Color: Biscuit

This is for the right hand side

A roll pin (spring pin) that secures rotating or sliding components by fitting into matched holes to hold shafts, levers, or brackets in place. Replaces a worn or damaged pin to restore proper mechanical engagement. What it does:

• Holds shafts, levers or hinges in position by expanding into drilled holes for a snug, vibration-resistant fit
• Keeps pulleys, rollers, or linkages from moving out of alignment or sliding off their shafts
• Common symptom: loose or wobbling pulley, lever, or shaft where the retaining pin is worn or broken
• Common symptom: noisy or intermittent operation caused by a pin that no longer secures moving parts

• Inspect mating holes and shaft for wear; replace pin with correct size to ensure secure fit
• Use appropriate pliers or a pin punch and hammer to drive the pin in or out; support the assembly to avoid damage
• Wear eye protection when installing or removing roll pins—pins can snap or fly out under force
• If pin is difficult to remove or install, consider using penetrating oil or heating only per OEM guidance

Color: White. Size: 1 qt. can. Acrylic appliance paint.

This replacement receiver lens covers and protects the appliance's infrared/receiver area and indicator light while allowing signals and status lights to show through clearly. It restores proper protection and visibility for the sensor/indicator assembly. What it does:

• Protects the IR/receiver and indicator area from dust, spills, and impact
• Allows remote/IR signals and indicator lights to pass through without obstruction
• Replaces cracked, discolored or missing lens that can hide status lights or reduce signal clarity
• Helps maintain original appearance of the control/console area

• Disconnect power to the appliance before beginning any repair.
• Remove the control console or front panel per the service manual to access the lens.
• Handle the lens gently to avoid scratching; seat it into the bezel until it snaps or rests securely.

This track is the roller support that guides a sliding assembly for proper alignment and smooth movement, helping restore stable, quieter operation. It's a direct-fit replacement when the original track is worn, bent, or damaged. What it does:

• Guides rollers or glides so doors/drawers/drums move smoothly along their path
• Keeps the sliding assembly aligned to prevent sticking, wobbling, or binding
• Reduces noise caused by uneven or damaged tracks
• Restores proper movement after wear, corrosion, or physical damage

• Disconnect power (and water if applicable) before starting any repair
• Basic hand tools typically required; support the assembly to prevent drops
• Inspect associated rollers, clips, and fasteners and replace if worn
• Test the unit after installation to ensure smooth, quiet operation