Kenmore Refrigerator 106.58142801 (10658142801, 106 58142801) Parts

Replace your refrigerator's ice dispenser lever if it's cracked, broken, or missing. This paddle actuates ice dispensing from behind the door cover.

Ice maker not dispensing cubes properly? This stripper arm guides ice through the maker. Common fix when tabs break. Takes about 15 minutes to install.

This replacement receiver lens covers and protects the appliance's infrared/receiver area and indicator light while allowing signals and status lights to show through clearly. It restores proper protection and visibility for the sensor/indicator assembly. What it does:

• Protects the IR/receiver and indicator area from dust, spills, and impact
• Allows remote/IR signals and indicator lights to pass through without obstruction
• Replaces cracked, discolored or missing lens that can hide status lights or reduce signal clarity
• Helps maintain original appearance of the control/console area

• Disconnect power to the appliance before beginning any repair.
• Remove the control console or front panel per the service manual to access the lens.
• Handle the lens gently to avoid scratching; seat it into the bezel until it snaps or rests securely.

This small metal mounting clip secures the thermal fuse in place to maintain proper thermal contact and stable wiring. It helps keep the fuse positioned so the appliance can monitor temperature reliably and operate safely. What it does:

• Secures the thermal fuse to the appliance housing or duct to prevent movement
• Keeps the fuse in correct contact with temperature-sensing surfaces
• Helps prevent intermittent heating or thermal-sensor misreads caused by a loose fuse
• Useful when replacing a damaged or missing fuse retainer during fuse service

• One thermal fuse mounting clip

• Disconnect power to the appliance before servicing to avoid shock or injury
• Remove access panels per your model's service instructions to reach the fuse location
• Install clip in the same orientation as the original; use pliers if needed to seat it firmly
• Inspect the thermal fuse and wiring while installing; replace any damaged components per OEM guidance

Ice maker not cycling or producing ice? This wire harness restores electrical connections between your ice maker and refrigerator control board. Simple plug-in repair for most DIYers.

Refrigerator door gasket seals the door to maintain temperature and prevent air leaks. Replace if torn, cracked, or not sealing properly. Confirm fit with your model number.

Plastic divider panel for side-by-side refrigerator freezer compartments. Organizes frozen items and separates storage zones. Replace if cracked or broken.

Secures rotating shafts and levers in your refrigerator's ice dispenser mechanism. Replace if pin is sheared, worn, or missing to restore alignment.

Replacement screw for securing appliance panels, mounting brackets, and internal assemblies. Restores tight connections when original screws are missing or damaged.

Color: White. Size: 1 qt. can. Acrylic appliance paint.

Replacement grille for your refrigerator. Covers the front lower panel area. Order this part if your original grille is cracked, broken, or missing.

Secures the control box assembly in your refrigerator. Replace this clip if it's broken, cracked, or missing to properly mount the control housing.

This is a replacement mounting screw used to secure appliance panels and small components. It provides a correct-fit fastener to restore secure attachment and eliminate rattles or loose parts. What it does:

• Secures trim, panels, brackets, or small assemblies to prevent movement and vibration
• Restores proper alignment when a worn or missing screw causes loose parts or noise
• Works as a direct-replacement fastener where the OEM screw specification is required

• One replacement screw

• Use the correct driver bit to avoid stripping the head; do not overtighten
• Disconnect power and follow appliance safety guidelines when accessing internal components
• If the original mounting hole or threads are damaged, repair or replace the mounting hardware before reinstalling