Kenmore Washer 110.10202000 (11010202000, 110 10202000) Parts

Completely removed dryer drum cleaned surfaces ready for paint applied paint acquired from you it did a wonderful job with one can of paint will use for a while and acquire another can of paint for second coat thank you so much for your help the whirlpool dryer drum paint was exactly what it said it would do Read more

Replaced timer control unit, first time doing this. Read more

I bought a clutch liner kit installed it in 5 minutes now it spins faster than ever. Read more

I bought a part and it worked perfectly. I was able to connect a flexible pipe to the siphon valve and set up a grey water system from our washing machine. Read more

Weekend laundry became very noisy, our 1987 Whirlpool washer began doing a dance across the floor and the drum was banging into the inner cabinet. After doing some research and watching a few videos on Appliance parts pros website. I inspected the washer and noticed one leg the rubber coating disintegrated, decided to change all four legs, springs and lid switch. Hardest part of the job is getting the cabinet together. Ops check good. Read more

I had the problem couple years ago I bypassed unbalance switch it worked fine for a couple years and had the same problem again so ruled out unbalanced switch. Door lock light on and checked made sure wax motor pushed out all the way too the second switch for spin check OK, so took a chance on displacement switch x2. My family loves to over load it and also replaced by passed unbalance switch and boom every thing went back to normal. Its also good to clean every thing when apart. Read more

I found that the balance ring had popped loose from the top of the inner metal tub and had been scored so that the fluid was leaking out. So, I removed the metal shell of the washer, then the top plastic cover over the outer tub. I pulled out the old part and put on the new one. I had to give it a pretty good push downward to engage the clips and get it fully seated. I ran my hand along the inside of the metal tub to feel that the new balance ring was fully seated. I also used a short level to... Read more

The repair was simple. Having used Appliance Parts Pro in the past for much needed repair parts, I simply unplugged the machine, turned off the water and removed the drain hose and slid unit forward. I then removed the top control panel like last time, tilted the body forward and set it aside. I unfastened the upper hose to the water pump and slid what was left of the old shield out and slid the new replacement shield back into place then reattached the flex hose. The shield slipped right... Read more