Kenmore Dryer 110.77980210 (11077980210, 110 77980210) Parts

Genuine Whirlpool part

Timer Knob

4.9 (10)

By: Whirlpool

Part Number: WP688865

Color: Chrome. Measures about 2 inches in diameter.

Do-It-Yourself Stories from Customers like You Dryer timer knob broke Shirley N. • Rome , GA • August 30, 2014

Ordered a new one from AppliancePartspro.com. Read more

Genuine Whirlpool part

Dryer Lint Screen

5.0 (3)

By: Whirlpool

Part Number: WP689467

Dryer lint screen filters debris during drying cycles. Replace when torn, damaged, or clogged beyond cleaning. Verify fit with your model number.

Do-It-Yourself Stories from Customers like You Broken dryer drive belt and hole in lint screen Alan J. • Chester , PA • September 15, 2015

First off, truly impressed with the one day delivery via FEDEX. Ordered around noon or 1pm on a Friday and received it some time on the next day while at work. More time spent vacuuming the lint out from the inside and outside of the unit over the installation time. Although I removed the back for cleaning the repair starts with the removal of two sheet metal screws from the top lint trap opening, then the top pops up and two screws get removed from the top front which then lifts off. This... Read more

Genuine Whirlpool part

Screw

By: Whirlpool

Part Number: 486146

Size: 10-32 x 1/2 inch.

Genuine Whirlpool part

Spring, Door

By: Whirlpool

Part Number: 237979

Genuine Whirlpool part

Coil - Valve

By: Whirlpool

Part Number: 279058

Genuine Whirlpool part

Dryer Gas Valve And Burner Assembly

By: Whirlpool

Part Number: 279894

Complete burner assembly with gas valve, coils and igniter. Setup for natural gas.

Genuine Whirlpool part

Hinge Right Hand

By: Whirlpool

Part Number: 687905

(for the L/H hinge use 687905

Genuine Whirlpool part

Handle

5.0 (1)

By: Whirlpool

Part Number: WP3977746

Do-It-Yourself Stories from Customers like You The lever to turn on dryer was broken the handle was broken and the latch was broken David R. • Jemison , AL • February 09, 2015

I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more