Kenmore Dryer 110.86574100 (11086574100, 110 86574100) Parts

Genuine Whirlpool part

Hi-Limit Thermostat

4.9 (10)

By: Whirlpool

Part Number: 279052

L250-40. Dryer

This part fixes the following symptoms

Too hot
No heat or not enough heat

Do-It-Yourself Stories from Customers like You Dryer ran but had no heat William A. • Claverack , NY • December 04, 2014

I took the back off the dryer and found the hi-limit thermostat in pieces. I went to your web-site, found the part in the parts list, called you at 11:00 am saturday morning, ordered the part, and couldn't believe it when fed-ex showed up monday morning at 11:00 am, with the RIGHT part. Two days from Kentucky to upstate New York, in 2 days, over a weekend, I am impressed to say the least. Did I mention that the dryer is 27 years old. Read more

Genuine Whirlpool part

Timer Knob

4.9 (10)

By: Whirlpool

Part Number: WP688865

Color: Chrome. Measures about 2 inches in diameter.

Do-It-Yourself Stories from Customers like You Broken knob. Jp B. • Milford Mill , MD • February 27, 2023

Ordered a new knob. Read more

Genuine Whirlpool part

Screw

By: Whirlpool

Part Number: 486146

Size: 10-32 x 1/2 inch.

Genuine Whirlpool part

Seal, Blower Shaft

4.8 (12)

By: Whirlpool

Part Number: WP3394196

Do-It-Yourself Stories from Customers like You The motor on our clothes dryer was doing a "self protection" thermal or overload shutdown and there was a strong odor in the tub Jim S. • Fallon , NV • November 27, 2015

It took two repair attempts to fix the dryer. At first, I noticed that the rear felt seal was completely worn out, so I thought that extra friction between the tub and the rear panel might be causing the motor to have to work too hard and overheat. I ordered a new seal from appliancepartspros.com, and installed it according to their instructional video, but it did not correct the problem. Then I decided that the motor must be going bad, so I watched the on-line video on how to remove the... Read more

Genuine Whirlpool part

Handle

5.0 (1)

By: Whirlpool

Part Number: WP3977746

Do-It-Yourself Stories from Customers like You The lever to turn on dryer was broken the handle was broken and the latch was broken David R. • Jemison , AL • February 09, 2015

I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more