Kenmore Dryer 110.87294150 (11087294150, 110 87294150) Parts

Replaced the switch...your videos are great! Five minutes and the job was done..OK,maybe ten,but with no swearing either! Read more

It took two repair attempts to fix the dryer. At first, I noticed that the rear felt seal was completely worn out, so I thought that extra friction between the tub and the rear panel might be causing the motor to have to work too hard and overheat. I ordered a new seal from appliancepartspros.com, and installed it according to their instructional video, but it did not correct the problem. Then I decided that the motor must be going bad, so I watched the on-line video on how to remove the... Read more

I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more

Pry the top up from the front edge with a flat screw driver, the lid will hinge up and back, the heating element is on the left rear, it only takes a 1/4 nut driver to remove and replace Read more