Kenmore Dryer 110.95876402 (11095876402, 110 95876402) Parts

This pipe plug seals an unused or service opening in a household appliance's plumbing to stop leaks and prevent debris entry. It restores a watertight closure so the appliance can operate safely and without water loss. What it does:

• Plugs open pipe or hose fittings to prevent water leaks
• Helps maintain proper water flow by sealing unused ports
• Keeps debris and contaminants out of the plumbing system
• Can stop intermittent drips originating from service openings

• One pipe plug

• Turn off water supply and power to the appliance before starting work
• Hand-start threads to avoid cross-threading; tighten only to OEM torque or finger-tight plus a quarter-turn if unspecified
• If the original used sealant or gasket, replace with the same type per OEM instructions

This bracket is used to attach and is included in the igniter kit. Save money by ordering the igniter kit 279311.

This is a metal funnel duct that directs gas from the burner assembly into the dryer drum area. It channels the heated air produced by the gas burner so it flows efficiently through the drum for proper drying. Replace this part if you notice uneven heating, scorch marks near the burner area, or if the original funnel is cracked, corroded, or misaligned.

Directs heated air from dryer drum to household vent. Replace if cracked, damaged, or airflow is restricted. Confirms fit for compatible dryer models listed.

5-circuit wire harness connector for dryers. Connects wiring harness to control board. Replace if cracked, damaged, or pins are bent or corroded.

Size: 8-18 x 3/4 inch.

8-32 mounting screw for dryer assemblies. Replaces lost, stripped, or damaged screws during repairs or panel reinstallation. Essential hardware part.

Replaces a cracked, broken, or scuffed dryer outer door panel in Graphite finish. Restores door appearance and ensures proper handle mounting and fit.

Kit contains total of 8 screws. Approximate size - (Qty.4) #10-32 x 7/16" and (Qty.4) #10-24 x 7/16".