Kenmore Dryer 110.96580010 (11096580010, 110 96580010) Parts

Genuine Whirlpool part

Split-Phase Motor (29" 50Hz Export)

By: Whirlpool

Part Number: W11618508

This split-phase motor assembly powers a dryer's drum and blower on qualifying 29" export 50Hz models, restoring rotation and airflow for normal drying performance. Designed as a direct-replacement motor assembly. What it does:

Drives the dryer drum and blower fan to circulate air through the drum.
Helps re-establish regular tumbling and airflow when the motor has failed.
Commonly replaces motors that hum, do not start, or stop suddenly during cycles.

What's included: One split-phase motor assembly. Install notes:

Disconnect power before attempting service to avoid shock or injury.
Handle the motor and wiring harness carefully to avoid pinched wires or damaged terminals.

$219.35

Compare At:: $261.03
You Save:: $41.68

IN STOCK

Ships Tomorrow Guaranteed

Add to Cart

Genuine Whirlpool part

Dryer Drum Assembly

By: Whirlpool

Part Number: W10899578

This is the complete drum assembly for a clothes dryer - the large cylindrical tumbler where clothes are placed for drying. It rotates during the drying cycle to tumble clothes through heated air. Replace this assembly if the drum has cracks, holes, excessive wear marks, or if clothes are snagging or getting caught during operation.

$233.95

Compare At:: $275.65
You Save:: $41.70

IN STOCK

Ships Tomorrow Guaranteed

Add to Cart

Genuine Whirlpool part

Dryer Push To Start Knob

5.0 (1)

By: Whirlpool

Part Number: WP3957800

Color: White.

Do-It-Yourself Stories from Customers like You Knob to start dryer broke. Barbara E. • Buda , TX • May 12, 2020

Ordered the replacement parts and my husband did the repair. Knob works great now. Read more

$39.26

Compare At:: $46.72
You Save:: $7.46

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

Bumper (Grey)

By: Whirlpool

Part Number: 238614

Rubber bumper. Color: Grey.

$65.88

Compare At:: $68.38
You Save:: $2.50

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

Appliance Touch Up Paint

By: Whirlpool

Part Number: 799344

Color: White. Size: 1 qt. can. Acrylic appliance paint.

$152.99

Compare At:: $159.16
You Save:: $6.17

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

Clip, Wire Harness

By: Whirlpool

Part Number: WP98997

$9.49

Compare At:: $10.44
You Save:: $0.95

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

Screw

By: Whirlpool

Part Number: 486146

Size: 10-32 x 1/2 inch.

Genuine Whirlpool part

Endcap

By: Whirlpool

Part Number: 285508

Genuine Whirlpool part

Seal, Blower Shaft

4.8 (12)

By: Whirlpool

Part Number: WP3394196

Do-It-Yourself Stories from Customers like You The motor on our clothes dryer was doing a "self protection" thermal or overload shutdown and there was a strong odor in the tub Jim S. • Fallon , NV • November 27, 2015

It took two repair attempts to fix the dryer. At first, I noticed that the rear felt seal was completely worn out, so I thought that extra friction between the tub and the rear panel might be causing the motor to have to work too hard and overheat. I ordered a new seal from appliancepartspros.com, and installed it according to their instructional video, but it did not correct the problem. Then I decided that the motor must be going bad, so I watched the on-line video on how to remove the... Read more

Genuine Whirlpool part

Handle

5.0 (1)

By: Whirlpool

Part Number: WP3977746

Do-It-Yourself Stories from Customers like You The lever to turn on dryer was broken the handle was broken and the latch was broken David R. • Jemison , AL • February 09, 2015

I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more