Kenmore Dryer 110.97195500 (11097195500, 110 97195500) Parts

Genuine Whirlpool part

Cover

By: Whirlpool

Part Number: 3354454

$65.25

Compare At:: $72.48
You Save:: $7.23

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

Wire Harness

By: Whirlpool

Part Number: 3393781

$173.46

Compare At:: $187.30
You Save:: $13.84

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

High Limit Thermostat

4.0 (1)

By: Whirlpool

Part Number: 279048

L205-40. Dryer

This part fixes the following symptoms

No heat or not enough heat

Do-It-Yourself Stories from Customers like You No heat Robert F. • Fort Waayne , IN • March 31, 2016

Found that when I "jumped" the hi limit thermostat the gas valve operated. So just went ahead and R/R the Hi limit thermostat, thermo-fuse, and the cycling thermostat. No problems. Read more

Genuine Whirlpool part

Lens

5.0 (7)

By: Whirlpool

Part Number: WP3395196

Do-It-Yourself Stories from Customers like You Dryer light burned out and the cover disintegrated when I removed it Stephen C. • Hixson , TN • September 29, 2018

Ordered bulb and cover. Installed them. Read more

Genuine Whirlpool part

Light Bulb

5.0 (7)

By: Whirlpool

Part Number: WPA3167501

Do-It-Yourself Stories from Customers like You Lamp/bulb burnt out; filter screen needed replacement Ronald W. • Los Gatos , CA • March 13, 2016

Replaced bulb and screen. Read more

Genuine Whirlpool part

Door, Switch

By: Whirlpool

Part Number: 3394522

Genuine Whirlpool part

Hex Nut

By: Whirlpool

Part Number: WP3387709

Genuine Whirlpool part

Handle

5.0 (1)

By: Whirlpool

Part Number: WP3977746

Do-It-Yourself Stories from Customers like You The lever to turn on dryer was broken the handle was broken and the latch was broken David R. • Jemison , AL • February 09, 2015

I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more