Kenmore Dryer 110.97573200 (11097573200, 110 97573200) Parts

• No heat or not enough heat

Found that when I "jumped" the hi limit thermostat the gas valve operated. So just went ahead and R/R the Hi limit thermostat, thermo-fuse, and the cycling thermostat. No problems. Read more

It took two repair attempts to fix the dryer. At first, I noticed that the rear felt seal was completely worn out, so I thought that extra friction between the tub and the rear panel might be causing the motor to have to work too hard and overheat. I ordered a new seal from appliancepartspros.com, and installed it according to their instructional video, but it did not correct the problem. Then I decided that the motor must be going bad, so I watched the on-line video on how to remove the... Read more

When I found the dryer off Craigslist, I didn't notice until recently the front panel plug was missing. I ordered the plug from Appliance Parts Pros, got the part & installation took seconds as it was a snap-in part. Couldn't be any happier. Also discovered the drum would not light up when the door opened. Ordered the bulb also from Appliance Parts Pros. Unplugged the dryer, unscrewed the lens cover, removed the burned bulb, cleaned out the light area, installed the bulb, replugged the... Read more

I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more