Kenmore Freezer 253.28432804 (25328432804, 253 28432804) Parts

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation

A small replacement mounting clip that secures interior trim and panels to restore proper fit and reduce rattling. Use when a broken or missing clip leaves gaps or lets panels or trim sit loose on the appliance. What it does:

• Secures trim, access panels or small plastic covers to the appliance frame
• Restores proper alignment and helps eliminate panel vibration or rattling
• Replaces cracked, worn or missing clips that allow gaps or loose parts
• Works as a simple fastener where the original clip has failed

• Always disconnect power to the appliance before beginning any repair
• Clip typically installs with a push-fit or snap-in motion; a flat tool may help remove the old clip
• Handle surrounding trim gently to avoid cracking brittle plastic
• Verify correct clip orientation before snapping into place

This is an Energy Guide label that identifies the appliance's estimated energy use and efficiency in plain terms, helping owners and buyers compare operating cost at a glance. It replaces a missing or damaged factory energy label. What it does:

• Displays estimated annual energy use and efficiency information as shown on the original label
• Helps provide required energy-consumption info for resale, service, or homeowner reference
• Restores the appliance's visible energy information if the original label is unreadable or missing
• Keeps identification consistent with the manufacturer's energy-rating presentation

• Follow the appliance owner's manual or OEM instructions for correct label placement and compliance
• Handle the label by the edges to avoid smudges or fingerprints on printed areas
• Clean and dry the mounting area before applying if adhesive backing is present