Kenmore Refrigerator 253.56272406 (25356272406, 253 56272406) Parts

Spacer that maintains proper gap between fixed crusher blades in the ice bucket. Replace if broken, cracked, or missing to restore correct alignment.

Glass insert that sits in the crisper cover frame above your produce drawers. Replace this part if your original is cracked, broken, or missing.

Secures ice crusher components in place. Replace if pin is worn, missing, or broken to restore proper alignment and operation of crusher assembly.

This micro switch detects door or lid position and tells the appliance when the door is closed so cycles can start or safety interlocks stay engaged. It restores reliable door sensing and helps prevent operation with the door open. What it does:

• Acts as a position sensor that completes or breaks the control circuit when the door/lid is closed or opened
• Keeps the appliance from starting or continuing a cycle if the door is open (safety interlock)
• Common symptom fix: appliance won't start, stops mid-cycle, or shows door-related error codes
• Small electrical switch designed to mount at the door latch or frame and connect to the appliance wiring harness

• Disconnect power (unplug or shut off breaker) before attempting service
• Access may require removing panels, trim, or the door latch assembly; keep track of screws and fasteners
• Observe wiring orientation and connector positions; replace exactly as removed or tag wires

Regulates moisture in your refrigerator's crisper drawer. Replace this control assembly if the original is cracked, broken, or unresponsive.

Evaporator cover shroud assembly for side-by-side refrigerators. Protects internal components and channels airflow around the evaporator coils.

Positions and secures condenser tubing to maintain proper spacing. Replace if worn, broken, or missing to prevent vibration, rattling, and tube damage.

Secures the evaporator cover inside your refrigerator's freezer compartment. Replace this metal bracket if bent, broken, or missing to restore alignment.

Left hand side. For the right hand side order 241674402

Right hand side. For the left hand side order 241674401

This solenoid actuator is the electromechanical device that moves a latch or linkage when energized, restoring the appliance's intended mechanical action. It provides a direct replacement to re-enable reliable actuation. What it does:

• Converts electrical signal into a mechanical push or pull to operate a latch, door, dispenser or linkage
• Commonly used where a timed or motor-driven movement is needed during a cycle
• Symptoms this part can cause: appliance fails to actuate a door, latch, dispenser or similar mechanism when called for
• Replacing a worn or failed actuator restores proper mechanical response to control signals

• One solenoid actuator

• Disconnect power to the appliance before beginning work to avoid shock or unintended actuation
• Remove any panels or trim as needed to access the actuator; note wire and mounting locations for reassembly
• Reconnect wiring and test the function on a short cycle after installation

Insulator tube for side-by-side refrigerators. Protects and insulates water lines and hoses. Replace if cracked, damaged, or missing insulation.

Replace your refrigerator's handle trim lock if it's cracked, broken, or missing. This small locking component secures the handle trim assembly to the door.

This flat glass shelf replaces a damaged or missing freezer shelf to restore usable storage space and keep frozen items organized and level. Tempered glass provides a solid, easy-to-clean surface for freezer storage. What it does:

• Replaces a cracked, chipped or missing freezer shelf so food stays supported and stable
• Restores full shelf capacity and helps prevent items from falling through gaps
• Provides a smooth, flat surface that wipes clean of spills and frost
• Fits into existing freezer shelf supports or rails (verify fit for your model)

• Handle carefully—glass is heavy and can break; wear cut-resistant gloves and eye protection
• Remove food and shelving accessories from the freezer before installing
• Slide into existing shelf supports; do not force or bend supports during installation
• If shelf has clips or stops, reuse OEM hardware; replace broken supports before installing the glass