Kenmore Range 362.7115191 (3627115191, 362 7115191) Parts

Genuine Ge part

Panel, Oven Bottom

By: Ge

Part Number: WB53K35

Do-It-Yourself Stories from Customers like You The panel on the oven bottom was pitted and needed to be replaced Kenneth W. • Buffalo , MN • November 29, 2014

Simple as can be. Took 2 screws out, pulled out the old panel, and put the new one in. Done in five mintures Read more

Genuine Ge part

Range Top Support Rod

5.0 (3)

By: Ge

Part Number: WB6K8

Do-It-Yourself Stories from Customers like You I replaced the cooktop in my range. Carol Z. • Bronx , NY • November 02, 2020

My 12 year-old cooktop was rusted through in a couple of key places, but the rest of my range was in terrific shape, so I decided to order a replacement cooktop. The perfect part arrived quickly. When I took a closer look at the few connecting parts I thought I was going to pirate off the old cooktop, I saw some were rusty, particularly the two Guide Slides and one screw. I needed to buy a set of star drivers, too, as a #10 was needed. I put a little WD40 on the parts I had to remove when I... Read more

Genuine Ge part

Support Rivet

By: Ge

Part Number: WB10K14

Left hand side

Genuine Ge part

Safety Valve Assembly

5.0 (1)

By: Ge

Part Number: WB19K12

Do-It-Yourself Stories from Customers like You Oven thermocouple went bad Joe L. • Calhan , CO • September 02, 2016

Replaced the oven valve which had the thermocouple built in. Read more

Genuine Ge part

Pressure Regulator

By: Ge

Part Number: WB19K26

Genuine Ge part

Pilot Harness A

By: Ge

Part Number: WB19K5

Genuine Ge part

Pilot Oven Bur

By: Ge

Part Number: WB19K6

Genuine Ge part

Nut

By: Ge

Part Number: WB1K4

Genuine Ge part

Screw 12 - 14, 5/8S

4.0 (1)

By: Ge

Part Number: WB1K78

Do-It-Yourself Stories from Customers like You The valve for one burner was jammed in the open position the gas main had to be turned off Louis B. • Doral , FL • August 17, 2017

The screws ordered were the wrong type (I removed machine threads, the replacements were self threading) Not a problem.The screws fixing the burners to the top plate were badly rusted and the heads had to be drilled off. The remaining part of the screws had to be drilled out which meant that the self threading screws could then be used. Changing the valve was straight forward. No hitches whatsoever.The job took about eight hours over three days. Louis Trinidad Read more