Kenmore Range 362.72691890 (36272691890, 362 72691890) Parts
Genuine Ge part
By: Ge
Part Number: WB1K45
Do-It-Yourself Stories from Customers like You
I replaced the cooktop in my range. Carol Z. • Bronx , NY • November 02, 2020
My 12 year-old cooktop was rusted through in a couple of key places, but the rest of my range was in terrific shape, so I decided to order a replacement cooktop. The perfect part arrived quickly. When I took a closer look at the few connecting parts I thought I was going to pirate off the old cooktop, I saw some were rusty, particularly the two Guide Slides and one screw. I needed to buy a set of star drivers, too, as a #10 was needed. I put a little WD40 on the parts I had to remove when I...
Read more
More
$5.95
- Compare At:
-
$8.36
- You Save:
-
$2.41
Genuine Ge part
By: Ge
Part Number: WB1K53
Mounting screw that secures the hinge assembly on electric and gas ranges. Replace this fastener if the original is stripped, missing, or damaged.
More
$4.58
- Compare At:
-
$8.36
- You Save:
-
$3.78
Genuine Ge part
By: Ge
Part Number: WB2K66
Right-side guide support secures sliding drawer or shelf rails on your range. Replace if cracked, broken, or worn to restore smooth tracking and alignment.
More
$7.95
- Compare At:
-
$9.54
- You Save:
-
$1.59
Genuine Ge part
By: Ge
Part Number: WB32K2
Cushions your range oven door perimeter to prevent metal contact and reduce heat loss. Replace when worn, compressed, or door closes harshly. Confirm fit.
More
$14.95
- Compare At:
-
$40.56
- You Save:
-
$25.61
Genuine Ge part
By: Ge
Part Number: WB39K16
Drawer slide rail for electric and gas ranges. Mounts to the drawer box to enable smooth gliding. Replace if bent, broken, or worn for proper operation.
More
$20.95
- Compare At:
-
$30.75
- You Save:
-
$9.80
Genuine Ge part
By: Ge
Part Number: WB34K5
Protective wire cover for range burner igniter wires. Replaces cracked, broken, or missing covers. Shields wiring from damage inside the range cabinet.
Do-It-Yourself Stories from Customers like You
Degraded burner igniter wires Richard W. • Bakersfield , CA • August 19, 2016
Checked online instructions for range top ands rear upright removal. Cleaned inside surfaces before removing individual wires one at a time. Ran the new wires through retainers first, then to the correct igniters next. Replaced removed parts to restore.
Note: The remove the top burner screws from the cook top before trying to remove it. Otherwise, you will bend the burner gas supply tubes and possibly damage them if not done in sequence.
Utube mentioned using a screwdriver for the cook top...
Read more
More
$7.40
- Compare At:
-
$16.04
- You Save:
-
$8.64
Genuine Ge part
By: Ge
Part Number: WB01K10008
Cooktop mounting screw secures the cooktop to frame or brackets. Replace if stripped, missing, or rusty to eliminate wobble, rattling, or lifted corners.
Do-It-Yourself Stories from Customers like You
Oven lock failed so self cleaning unit would not engage Alice L. • Martinez , CA • September 17, 2018
Replaced old lock and installed replacement lock and now have a happy wife.
Read more
More
$11.95
- Compare At:
-
$14.22
- You Save:
-
$2.27
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB01K10093
This speed nut is a clip-on fastener that provides threads for a screw on the appliance. It secures sheet-metal panels, brackets, or trim and helps keep assemblies tight under vibration and repeated use.
- Provides captive threads so a screw can tighten into thin sheet metal
- Helps secure panels, brackets, and trim pieces in place
- Replace if a screw spins without tightening, a panel rattles/feels loose, or the original clip is missing or damaged
- Restores a snug, reliable attachment point without a loose nut
What's included: One speed nut Install notes:
- Disconnect power and, if applicable, shut off gas; allow the appliance to cool before servicing
- Note the clip's orientation; slide it onto the panel edge or stud as designed
- Start the screw by hand to avoid cross-threading; do not overtighten
- Wear cut-resistant gloves when handling sheet-metal parts
More
$7.95
- Compare At:
-
$9.54
- You Save:
-
$1.59
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB34K10086
Stamped metal shield that protects the oven's lower cavity and insulation from excessive heat. Replace if cracked, rusted, corroded, or damaged.
More
$104.16
- Compare At:
-
$121.03
- You Save:
-
$16.87
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB1K5
Size: 8-18 x 1/2 inch.
Do-It-Yourself Stories from Customers like You
Oven not lighting John D. • Orlando , FL • January 16, 2024
We replaced the igniter. To do the job right you need to pull the oven off the wall (this was the 6 burner with griddle dual oven). you need to get to the igniter plug by taking off the entire back.... easier than it sounds... the hardest part is sliding the stove out and back in... I only need a 1/4 in driver for the whole job.... it is easier if you take the oven doors off...
Read more
More
$7.95
- Compare At:
-
$9.38
- You Save:
-
$1.43
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WZ4X345D
$21.95
- Compare At:
-
$26.34
- You Save:
-
$4.39
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB1K83
Secures the burner valve assembly to your gas range. Replace this mounting screw if worn, missing, or stripped to restore proper valve alignment and support.
More
$6.72
- Compare At:
-
$8.36
- You Save:
-
$1.64
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB01K10003
Black mounting screw secures end caps on electric ranges. Replace missing, stripped, or damaged screws to properly fasten decorative end panels.
More
$4.57
- Compare At:
-
$8.36
- You Save:
-
$3.79
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB07K10003
Black right-side end cap that finishes and secures trim, rail, or channel ends on your range. Replace if cracked, broken, or missing to restore fit.
More
$59.48
- Compare At:
-
$70.19
- You Save:
-
$10.71
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB1K44
The range latch screw is a small fastener used to secure the door latch mechanism or latch strike plate firmly to the range frame. It keeps the latch components from shifting or loosening over time with repeated use. Replace this screw when the original is stripped, missing, or corroded, causing the latch assembly to feel loose or the oven door to not close securely.
Do-It-Yourself Stories from Customers like You
Oven lock failed so self cleaning unit would not engage Alice L. • Martinez , CA • September 17, 2018
Replaced old lock and installed replacement lock and now have a happy wife.
Read more
More
$7.00
- Compare At:
-
$8.36
- You Save:
-
$1.36
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB2K36
Secures your range power cord at cabinet entry to prevent wire damage and disconnection. Replace if cord is loose or clamp is cracked. Confirm fit with your model number.
More
$7.00
- Compare At:
-
$8.36
- You Save:
-
$1.36
Out Of Stock
Usually ships within 4 - 14 days