Kenmore Range 362.75581891 (36275581891, 362 75581891) Parts

Genuine Ge part

Knob - Control

By: Ge

Part Number: WB03K10019

Genuine Ge part

End Cap Lt (Blk)

By: Ge

Part Number: WB07K10004

Genuine Ge part

Support Rivet

By: Ge

Part Number: WB10K14

Left hand side

Genuine Ge part

Top Burner Igniter

4.0 (1)

By: Ge

Part Number: WB13K10003

Electrode

Do-It-Yourself Stories from Customers like You Ignitor discolored and hard to lite burner had to start using lighter William S. • Bel Air , MD • November 28, 2016

Watch U-tube video but wrong for my stove Disconnected burner from top which I did not have to do All I had to do was pull ignitor straight up (wire would come with it and disconnect wire from ceramic then push back into place Because I disconnected via video insturction turned a five minute job into a 30 minute job Burner ignites now Wife happy (best) Read more

Genuine Ge part

Door Handle (Blk)

By: Ge

Part Number: WB15K10002

Genuine Ge part

Burner - Small

By: Ge

Part Number: WB16K10006

Genuine Ge part

Burner - Lrg

By: Ge

Part Number: WB16K10007

Genuine Ge part

Regulator, Pressure

4.7 (6)

By: Ge

Part Number: WB19K10001

Do-It-Yourself Stories from Customers like You Regulator was bad Charles S. • Phoenix , AZ • July 24, 2017

Changed it out Read more

Genuine Ge part

Screw

By: Ge

Part Number: WB1X5716

Genuine Ge part

Speed Nut (12-Pack)

5.0 (1)

By: Ge

Part Number: WB1X5743D

Includes 12 speed nuts.

Do-It-Yourself Stories from Customers like You Damaged broiler drawer Gary S. • Katy , TX • February 28, 2016

Ordered replacement parts Read more

Genuine Ge part

Burner Valve

By: Ge

Part Number: WB21K21

Genuine Ge part

Elbow Hi-Broil

By: Ge

Part Number: WB28K10018

Genuine Ge part

Tube Manifold Supply

4.5 (2)

By: Ge

Part Number: WB28K10021

Do-It-Yourself Stories from Customers like You Tube manifold from gas supply to stovetop broke Rick W. • Three Rivers , MI • November 15, 2014

I had to open up the side panel of the range and pull up the stove top. Unscrewed both ends of the old tube and pulled it out. Installed new tube and screwed the top into place. Had to do a little bending of the tube to get it to fit. The "supply" end was a little shorter than the original, and the bends were a little different, but not too bad that I couldn't make it work. Screwed on the bottom end of the tube. Read more