Kenmore Refrigerator 363.58257896 (36358257896, 363 58257896) Parts

Ordered the parts i needed to fix it from Appliance Parts Pro Got them very fast put them in and it's ready to ga Read more

Went online to youtube for videos. Could not find a video of draw front but figured it out. Read more

The replacement was made to fit various models. None of the instructions really fit my model. Ended up spending less time actually replacing it than reading the instructions. Took about 15 minutes. Needed a zip tie to hold the wires to back, otherwise the ice drawer would not shut. Works great, faster than the original, makes 8 cubes every 40 minutes. Ice feeler seems more flimsy than the old design which was a lift up wire. New design is a plastic paddle with an on off switch, which could... Read more

Easy swap out after watching video Read more

The ice dispenser door was not closing tightly. As a result, there was frost build up in the ice chute, which also was allowing ambient air and temperature into the freezer compartment. Upon further inspection, there was black “schmutz” on the ice door, and the rubber ice funnel and deflector parts were deteriorating. Because the door was not closing tightly, I also assumed that the door-closing spring was week. The parts I ordered were: ice door assembly, ice funnel, ice deflector, spring and... Read more

I replaced the door stop. Fortunately, I did NOT follow the advice on your Questions and Answers discussion and remove the door to do this: "You will need to remove the door hinge cover and hinge from the top of the door. Then lift and remove the door from the refrigerator. Lay the door on a soft surface and remove the screws holding the door stop WR2X9302 in place. Reinstall in reverse order." The two screws are fairly easy to remove with a socket wrench with the door in place. Read more

Ordered parts and watched the video. Read more

Ordered top and bottom drawers and right and left side rails. Hardest thing was getting out the broken drawers on out took me 15 minutes to re install the new hardware. Read more

This recess heater was a last resort 'nuclear' option that I never employed. First repair was to replace the solenoid that keeps the little door from staying open and letting room air back up it. Also replaced the gaskets around both doors which allowed the freezer and fridge sides to stay at the right temp. That seems to have done the trick. To install this part would be a herculean task involving complete and total disassembly of the door and seal 'tracks'...this seemed fraught with... Read more

I ended up replacing the circuit board, solenoid, and ice door. While I had it torn apart, I went ahead and replaced the rubber pieces that funnel the ice into the glass. Read more