Kenmore Refrigerator 363.58772894 (36358772894, 363 58772894) Parts

The handles were a simple fix. Just pop out the door trim, which I did by pulling on the very top and bottom of the trim to get it started. Then removed two star screws from the handle. I had to work the chrome plastic top and bottom handle caps off, then reversed the process for installing the new handle. The Recess/Dispenser was a bit more tricky. I pried the trim and control panel off with a putty knife, then the rest was fairly obvious, such as removing screws and wiring connectors. ... Read more

The ice dispenser door was not closing tightly. As a result, there was frost build up in the ice chute, which also was allowing ambient air and temperature into the freezer compartment. Upon further inspection, there was black “schmutz” on the ice door, and the rubber ice funnel and deflector parts were deteriorating. Because the door was not closing tightly, I also assumed that the door-closing spring was week. The parts I ordered were: ice door assembly, ice funnel, ice deflector, spring and... Read more

Replaced both the inlet water valve and the water dispenser valve. Replaced water dispenser switch and water filter. Read more

I removed ice maker, cleared out frozen food to make room for drill, removed broken support, & drilled out old pop rivet (covering the area below with a cloth to catch the metal shavings). Then I carefully straightened the metal support, loosely installed the new support, and pop-riveted it onto the support using the same size rivet. I reinstalled the ice maker, replaced the frozen food, and turned the ice maker back on. No issues. Read more

I welded the auger first but it didnt seem to last. i then took the whole thing apart and found more worn parts so i ordered all of the parts i needed and replaced them. it now works like new. Read more

New switch for water dispenser and new inlet valve. Read more

I loosened all bracket screws around door inside edge. I removed the old seal and replace it with the new seal. The most difficult part was adjusting the seal properly. This required loosening the screws two or three at a time and pulling the rubber seal outwards from under the bracket. The seal was wrinkled coming out of the cardboard package. I followed the instructions dipping the seal in hot water and this relaxed the rubber removing the kinks. Read more