Kenmore Refrigerator 363.59479990 (36359479990, 363 59479990) Parts

I fixed the drip with a bit of silicone. I fixed the rusty parts Auger & End Plate by replacing them. I repaired the dispenser by replacing the defective door. I used the various videos connected with the parts ( including related parts that I did not replace but required removing them first) to learn and confirm how to properly remove and replace the parts. These were incredibly valuable, Thank You! Read more

I removed ice maker, cleared out frozen food to make room for drill, removed broken support, & drilled out old pop rivet (covering the area below with a cloth to catch the metal shavings). Then I carefully straightened the metal support, loosely installed the new support, and pop-riveted it onto the support using the same size rivet. I reinstalled the ice maker, replaced the frozen food, and turned the ice maker back on. No issues. Read more

I welded the auger first but it didnt seem to last. i then took the whole thing apart and found more worn parts so i ordered all of the parts i needed and replaced them. it now works like new. Read more

• Light not working

Watched the video to replace it, did pretty much the same thing (switch was a little tough to pry out without damaging the fridge). Once old one was out, new one was installed in about 30 seconds. Read more

New switch for water dispenser and new inlet valve. Read more

Determined from the schematic on the inside of the cover of the icemaker that the likely problem was the "stop" micro switch.... Took the whole thing apart and confirmed the switch was defective. Replaced it with a standard DPDT switch - for a temporary fix. Went on line to find replacement. Bought it from APP Parts Pros. replaced DPDT switch with micro.. all is well.... saved at least $150 by not having a repair person come to the house - felling good about this..... Read more