Kenmore Refrigerator 363.59499990 (36359499990, 363 59499990) Parts

I researched the problem and determined that the only thing that can cause this was compressor bad or not starting. Since it was cold the day before I felt it had to be the starter parts and ordered them. It was also very important to clean the coil which I believe caused the over heating. Read more

I needed to find a parts supplier who could provide a replacement part at a reasonable price. I first tried the manufacturer, General Electric, but they only showed freezer replacement parts for the model of my side-by-side refrigerator. In looking over a list of parts available for this model there seemed to be a possible part that sounded like a match but there was no picture to confirm that this was the correct replacement part. When i clicked the Appliance Parts Pros web site They had a... Read more

Swapped it out for new tube. Take 5 minutes and zero effort. The drain tube will clog with mold. You can clean it out but the tube will clog again despite's you best efforts as the tube wall provide a great habitat. Ordered new tubes to facilitate swap-outs. Old tubes can be cleaned but will recolonize quickly. Read more

Replaced the deflector Read more

I replaced the Evaporator Fan Motor the brackets were rusty so I ordered them. Read more

Disassemble, replace, reassemble Read more

I fixed the drip with a bit of silicone. I fixed the rusty parts Auger & End Plate by replacing them. I repaired the dispenser by replacing the defective door. I used the various videos connected with the parts ( including related parts that I did not replace but required removing them first) to learn and confirm how to properly remove and replace the parts. These were incredibly valuable, Thank You! Read more

4 screws Read more

Determined from the schematic on the inside of the cover of the icemaker that the likely problem was the "stop" micro switch.... Took the whole thing apart and confirmed the switch was defective. Replaced it with a standard DPDT switch - for a temporary fix. Went on line to find replacement. Bought it from APP Parts Pros. replaced DPDT switch with micro.. all is well.... saved at least $150 by not having a repair person come to the house - felling good about this..... Read more

This was a very easy repair, the on-line video at AppliancePartsPros.com was helpful. The Helix was spinning freely (meaning, the Auger Blade was not holding it in place on the Auger). Pulling the assembly apart was a snap, and very logical (the video is perfect if you get lost). The family is now enjoying both crushed and cubed ice - and the redesign of the Auger Blade seems to prevent clogging in the ice shoot. Read more

I ordered a clip retainer which hold the compressor in place. First, I discovered there are four clips and the one which I could easily move or turn by hand I ordered a replacement. The part came fast. In less than two minutes I had completed the repair. Read more