Kenmore Refrigerator 363.59499991 (36359499991, 363 59499991) Parts
Genuine Ge part
By: Ge
Part Number: WR2X9299
Closes and protects the end of your refrigerator's mullion air duct on the door jamb. Replace this cap if cracked, broken, or missing to maintain a finished appearance.
More
$9.24
- Compare At:
-
$10.16
- You Save:
-
$0.92
Genuine Ge part
By: Ge
Part Number: WR02X40305
Do-It-Yourself Stories from Customers like You
Leaking vaporizer pan Rich M. • La Verne , CA • May 04, 2019
Installed new stainless steel pan replacing broken original plastic pan and installed new rubber grommets for the compressor
Read more
More
$11.83
- Compare At:
-
$13.01
- You Save:
-
$1.18
Genuine Ge part
By: Ge
Part Number: WR2X8654
Mullion air duct that directs airflow between refrigerator compartments. Replace if cracked, broken, or missing to restore proper air circulation.
More
$6.46
- Compare At:
-
$7.11
- You Save:
-
$0.65
Genuine Ge part
$8.76
- Compare At:
-
$9.64
- You Save:
-
$0.88
Genuine Ge part
By: Ge
Part Number: WR51X10029
Fix frost buildup on evaporator coils or a freezer that keeps icing up. This defrost heater assembly melts accumulated ice to restore proper cooling.
Do-It-Yourself Stories from Customers like You
Fresh foods section was not cooling but freezer was cold Cynthia B. • Loganville , GA • January 19, 2018
After reviewing a number of testimonials and your videos from your APP.com site I determined my most likely problem was either the defrost heater, thermostat, timer or possibly all three. The real challenge now began. Getting to the specific parts with my specific model number was a real challenge. It was not as easy as removing the light guard and 5 screws since my model had two Track Cant Shelf vertical rails restricting the removal of the back panel. Also, these rails could not be removed...
Read more
More
$99.28
- Compare At:
-
$118.14
- You Save:
-
$18.86
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR17X4358
Internal water storage reservoir for refrigerator dispensers. Installs inside the fresh food compartment. Replace if cracked, leaking, or split.
Do-It-Yourself Stories from Customers like You
Nasty water tank for fridge dispenser Prather, T. • Minden , NV • September 22, 2014
This part was easy to install by following the directions from other users here. As long as you get the right hoses connected in the right places, everything else was straight forward. Takes a few minutes for the tank to initially fill and pressurize and clear the air in the line and then you're on your way to clean fresh water!
Read more
More
$122.48
- Compare At:
-
$145.75
- You Save:
-
$23.27
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X4754
Secures water and drain tubing to prevent leaks, noise, and vibration. Replace if loose, cracked, or missing. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$9.54
- Compare At:
-
$10.49
- You Save:
-
$0.95
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X7309
This solenoid saddle is a small mounting bracket that secures a refrigerator solenoid in the correct position. By preventing movement and misalignment, it helps the linked mechanism engage smoothly and consistently.
- Secures the solenoid to its housing or frame to prevent shifting
- Maintains proper alignment for reliable actuation
- A worn or broken saddle can cause buzzing/chattering and intermittent operation
- Restores stable mounting to help the connected mechanism work correctly
What's included: 1 solenoid saddle Install notes:
- Disconnect power; shut off water supply if working near water lines
- Access the solenoid assembly and note the original saddle's orientation
- Transfer the solenoid into the new saddle and reuse existing fasteners/clips
- Smooth operation before reassembling panels
Do-It-Yourself Stories from Customers like You
Ice dispenser crushing ice only no cubes Eric W. • Copper Canyon , TX • June 27, 2014
Easy fix once I found the problem. Broken solenoid sleeve. Part cost $2.58 + shipping. 10 minute repair.
Read more
More
$9.88
- Compare At:
-
$10.87
- You Save:
-
$0.99
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR17X4207
Ice crusher not working or slow crushed ice production? This helix front feeds ice to crushing blades. Moderate DIY repair—replace with auger for best results.
Do-It-Yourself Stories from Customers like You
Ice crusher repair GE Monogram counter depth. Glenn J. • El Cajon , CA • July 27, 2020
This was a very easy repair, the on-line video at AppliancePartsPros.com was helpful.
The Helix was spinning freely (meaning, the Auger Blade was not holding it in place on the Auger).
Pulling the assembly apart was a snap, and very logical (the video is perfect if you get lost).
The family is now enjoying both crushed and cubed ice - and the redesign of the Auger Blade seems to prevent clogging in the ice shoot.
Read more
More
$36.95
- Compare At:
-
$43.97
- You Save:
-
$7.02
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR1X1366D
Includes 12 washers.
Do-It-Yourself Stories from Customers like You
A fin on the plastic auger broke off and needed to be replaced John M. • Massanutten , VA • August 08, 2015
I ordered a replacement auger from AppliancePartsPros.com. Upon receipt of the new auger, I watched the repair video and took the ice crusher apart. I found several other parts that needed to be replaced as well. Once All the parts were received, I again watched the video. The video was not specific enough to show how to reassemble the ice crusher blades and the two types of washers. I found another video on YouTube that walked me through specific details of assembly and everything went...
Read more
More
$32.95
- Compare At:
-
$38.88
- You Save:
-
$5.93
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR23X10108
Wire harness assembly that routes electrical connections between refrigerator components. Replace if wires are damaged, frayed, broken, or corroded.
Do-It-Yourself Stories from Customers like You
Ice maker got no water. The water through the door worked, checked back of frig long story short needed harness Robert C. • Phoenix , AZ • August 05, 2019
Replacing the wiring harness. Water to ice easy.
Read more
More
$50.95
- Compare At:
-
$60.12
- You Save:
-
$9.17
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR32X1492
Upper vegetable crisper drawer pan for refrigerators. Replaces cracked, broken, or missing drawer liners. Restores produce storage in upper location.
Do-It-Yourself Stories from Customers like You
Refrigerator is 25 years (ge hotpoint) old but still works great crisper drawers were broke and would not open Ed R. • Mason , OH • January 20, 2020
Ordered top and bottom drawers and right and left side rails. Hardest thing was getting out the broken drawers on out took me 15 minutes to re install the new hardware.
Read more
More
$138.38
- Compare At:
-
$166.06
- You Save:
-
$27.68
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR17X1363
Ice won't crush and gets stuck between blades? This moving dispenser blade restores crushing function. Simple DIY fix for side-by-side refrigerators.
More
$11.93
- Compare At:
-
$12.34
- You Save:
-
$0.41
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR17X2061
Replaces the outer housing that supports your refrigerator's ice crusher and dispenser chute. Order a new housing if yours is cracked or broken.
Do-It-Yourself Stories from Customers like You
Ice storage bin had problem dispensing James W. • Haltom City , TX • November 28, 2016
Replaced auger, crusher housing and end nut
Read more
More
$37.95
- Compare At:
-
$44.78
- You Save:
-
$6.83
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WZ2X464D
$27.95
- Compare At:
-
$32.98
- You Save:
-
$5.03
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR01X10601
This is a 10-24 x 1.0 inch screw used to secure appliance panels and components. It replaces worn or missing fasteners to restore proper fit and reduce rattling or loose parts for safer, quieter operation. What it does:
- Secures panels, brackets, and trim to keep components aligned and stable
- Stops vibrating or rattling caused by loose or missing screws
- Restores proper grounding/attachment where a threaded fastener is required
- Matches OEM thread size and length for a correct fit when replacing damaged screws
What's included: One 10-24 x 1.0 in screw Install notes:
- Use the correct driver bit and turn carefully to avoid stripping the head or threads
- Do not overtighten; snug until secure to prevent damage to mating parts
- Replace like-for-like with the same thread size and length for proper fit
- Disconnect power and follow appliance safety guidelines before accessing internal components
More
$8.76
- Compare At:
-
$9.64
- You Save:
-
$0.88
Out Of Stock
Usually ships within 4 - 14 days