Kenmore Refrigerator 363.59522994 (36359522994, 363 59522994) Parts
Genuine Ge part
By: Ge
Part Number: WR2X8516
$17.34
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X8655
Plastic air duct that directs cold air from the freezer to the fresh food compartment through the mullion. Replace if cracked, broken, or missing.
More
$9.34
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X8721
$10.55
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X9000
Secures the condenser unit in your refrigerator. Replace if loose, broken, or causing vibration noise. Verify fit with your model number before ordering.
More
$9.24
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X9431
$30.20
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR40X1730
This breaker strip is the wire terminal connector that secures and routes appliance wiring, restoring stable electrical connections and preventing loose or corroded contacts. It's a direct-fit service part used where multiple wires meet at a single terminal. What it does:
- Provides a secure terminal point for connecting and routing wires to multiple components
- Maintains consistent electrical contact to prevent intermittent operation
- Helps reduce arcing or sparking at worn or loose connection points
- Keeps wiring organized and aligned for proper fit and insulation
What's included:
Install notes:
- Disconnect power to the appliance before inspecting or replacing the part
- Verify wire routing and terminal positions; transfer wires one at a time to avoid mis-wiring
- Use basic hand tools; avoid over-tightening terminals to prevent damage
- If terminals or surrounding wiring show burn damage, replace damaged wiring.
More
$28.58
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR40X1731
$12.11
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR40X1734
$41.22
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR40X1735
$17.67
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR40X1736
$11.72
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR40X1737
$35.95
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR40X1738
$44.34
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR57X10014
$61.95
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WZ6X136
$9.74
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X8474
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
This part fixes the following symptoms
-
Leaking
-
Ice maker not making ice
See more...
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
Genuine Ge part
By: Ge
Part Number: WR2X7491
This small shim adjusts the alignment and gap spacing of your refrigerator door hinges. It ensures proper door alignment and helps maintain an even seal around the door perimeter. Use this part if your refrigerator door doesn't close properly, has uneven gaps, or if the door appears misaligned.
Do-It-Yourself Stories from Customers like You
Door cam needing replacement and vegetable draw front broken Stephen M. • Norfolk , MA • March 22, 2015
Went online to youtube for videos. Could not find a video of draw front but figured it out.
Read more
More