Kenmore Dryer 417.88076700 (41788076700, 417 88076700) Parts

Replacement light pipe lens for dryer control panel display. Guides LED light to indicator window. Order new part if original is cracked or missing.

Technical data sheet for your dryer. Provides specifications, wiring diagrams, and installation details. Replace if lost, damaged, or illegible.

Replace your dryer's control panel if cracked, damaged, or worn. This panel covers the control area and houses interface components. Direct fit part.

This mounting bracket secures internal components in place to keep appliance parts aligned and stable during normal use. Replacing a damaged bracket restores proper fit and support for affected assemblies. What it does:

• Provides structural support for internal panels or assemblies to prevent shifting and noise
• Helps maintain proper alignment of moving parts to reduce wear
• Stops rattling or vibration caused by a broken or bent bracket
• Keeps connected components securely attached after repair or reassembly

• One mounting bracket

• Disconnect power and water before starting any repair
• Inspect surrounding fasteners and hardware; replace any stripped screws for a secure fit
• Use proper-size tools to avoid damage to mounting holes or nearby components

This replacement plug seals and covers an appliance opening to keep out water, dirt and debris and to protect internal components. It restores a finished appearance and helps maintain safe, reliable operation. What it does:

• Seals service or access openings to prevent moisture and debris intrusion
• Covers unused ports or cutouts for a clean, finished look
• Helps protect wiring and internal parts from contamination
• Prevents drafts that can affect temperature-sensitive compartments

• Always disconnect power before accessing appliance internals
• Press-fit or snap-in design — align and push into place until fully seated
• Inspect surrounding area for damage; replace if plug is torn or brittle

This control panel is the user-facing electronic console that lets you select oven/cooktop functions and settings. It replaces a damaged or unresponsive panel to restore normal control and clear readout operation. What it does

• Houses the touchpads/buttons and display used to set temperature, timers and cooking modes
• Sends user commands to the oven control board so cycles start and stop as expected
• Can resolve symptoms such as unresponsive buttons, blank or flickering display, or incorrect mode selection
• Interfaces with the range's control electronics to provide visible status and feedback

• One control panel

• Disconnect power at the breaker or unplug the appliance before starting
• Handle the display and ribbon/connector areas carefully to avoid damage
• Basic hand tools are typically required; follow the service manual for panel removal and reassembly

The Motor is an OEM part for Frigidaire dryers. It is responsible for driving the drum rotation in the dryer, allowing for the tumbling and drying of clothes. It converts electrical energy into mechanical motion, providing the necessary power to spin the drum and circulate air for efficient drying.

Causes of a faulty dryer motor can include wear and tear over time, electrical malfunctions, or physical damage. These factors can result in issues such as the drum not spinning, unusual noises during operation, or the dryer not heating properly.

Symptoms of a bad dryer motor may include:

• The drum not rotating or spinning
• Unusual grinding or squealing noises while the dryer is in use
• Dryer not generating heat or insufficient drying performance

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.